User manual HITACHI CP-RS55

[. . . ] Projector CP-RS55 User's Manual ­ Quick Guide ENGLISH Thank you for purchasing this projector. WARNING Before using, read the "User's Manual - Safety Guide" and these manuals to ensure correct usage through understanding. After reading, store them in a safe place for future reference. NOTE · The information in this manual is subject to change without notice. [. . . ] · Except for an emergency, whenever you turn the projector off, obey the procedure of the following "Turning off the power", and do not disconnect the power cord until the procedure is completed. Neglect causes a damage of the electrode and un-lighting of the lamp. · This Projector is controlled by an internal microprocessor. Under certain exceptional circumstances, the projector may not operate correctly even for turning off the power. In such a case, please push the restart switch by Restart switch using a pin or similar. After making sure that the power indicator lights to solid orange, set the power switch to the OFF position. Only push the restart switch in these exceptional instances. · When a power supply is shut off with a power failure or the restart switch, before turning on again, make the projector cool down at least 10 minutes without operating. CONTROL RGB S-VIDEO VIDEO AUDIO K on the projector or remote control. Press the STANDBY/ON buttonappear on the screen for approximately 5 The message "Power off?" will seconds. Power off? STANDBY/ON 2. button on the projector or remote control again while the message The projector lamp will go off, and the POWER indicator will begin blinking orange. Then the POWER indicator will stop blinking and light to solid orange when the lamp cooling is complete. POWER (Blinking orange) POWER (Solid orange) indicator lights to solid 3. Make sure that the powerPOWER indicator will goorange, set the power switch to the OFF position. Do not set the power switch to the OFF position while the POWER indicator is green or blinking. POWER (Solid orange) lens For 4. usedsafety purposes, disconnect the power cord if the projector to be for prolonged periods of time. 9 ENGLISH Maintenance Maintenance Lamp WARNING HIGH VOLTAGE HIGH TEMPERATURE HIGH PRESSURE The projector uses a high-pressure mercury glass lamp. The lamp can break with a loud bang, or burn out, if jolted or scratched, handled while hot, or worn over time. Note that each lamp has a different lifetime, and some may burst or burn out soon after you start using them. · Handle with care: jolting or scratching could cause the lamp bulb to burst during use. · If the indicators or a message prompts you to replace the lamp (see the "User's Manual - Operating Guide"), replace the lamp as soon as possible. Using the lamp for long periods of time, or past the replacement date, could cause it to burst. Do not use old (used) lamps; this is a cause of breakage. 10 Maintenance Lamp (continued) When the indicators or a message prompts you to replace the lamp, replace the lamp as soon as possible. Turn the projector off, and unplug the power cord. Allow the lamp to cool for at least 45 minutes. [. . . ] Inserting the CD-ROM into an incompatible CD drive may produce a loud noise, which in turn MAY RESULT IN EAR AND SPEAKER DAMAGE!· After using CD-ROM, please put it into CD case and keep it. Please keep the CD neither in direct sunlight nor in a high temperature and high humidity environment. NOTE · The information in the CD-ROM is subject to change without notice. [. . . ]