User manual HITACHI CP-X10000W

[. . . ] Projector CP-X10000/CP-WX11000/CP-SX12000 User's Manual (detailed) ­ Operating Guide Thank you for purchasing this projector. WARNING Before using this product, please read the "User's Manual Safety Guide" and related manuals to ensure the proper use of this product. After reading them, store them in a safe place for future reference. About this manual Various symbols are used in this manual. The meanings of these symbols are described below. [. . . ] · Nothing (blank) is shown in the "PROJECTOR NAME" field until you setup the item ( 58). · When the voltage level of the battery for the built in clock decreases, the set time may become incorrect even though accurate date and time are input. · IP ADDRESS, SUBNET MASK and DEFAULT GATEWAY indicate "0. 0. 0. 0" when DHCP is ON and the projector has not gotten address from DHCP server. Executing this item restarts and initializes the network functions. Choose the RESTART EXECUTE using the button . Then use the button SERVICE to execute. Network will be once cut off when choose restart. If DHCP is selected on, IP address may be changed. After selecting RESTART EXECUTE, NETWORK menu may not be controlled approx. 30 seconds. 60 SECURITY menu SECURITY menu This projector is equipped with security functions. From the SECURITY menu, items shown in the table below can be performed. To use SECURITY menu: User registration is required before using the security functions. Enter the SECURITY menu 1. Use the / buttons on the SECURITY menu to select ENTER PASSWORD and press the button. The ENTER PASSWORD box will be displayed. If you have forgotten your password 1. While the ENTER PASSWORD box is displayed, press and hold the RESET button on the remote control for about 3 seconds or press and hold the COMPUTER button for 3 seconds while pressing the button on the projector. The 10 digit Inquiring Code will be displayed. Contact your dealer with the 10 digit Inquiring Code. Your password will be sent after your user registration information is confirmed. · If there is no key input for about 55 seconds while the Inquiring Code is displayed, the menu will close. If necessary, repeat the process from 1. Use the / / / buttons to enter the registered password. This password can be SECURITY PASSWORD CHANGE). Move the changed ( cursor to the right side of the ENTER PASSWORD box and press the button to display the SECURITY menu. · It is strongly recommended the factory default password to be changed as soon as possible. · If an incorrect password is input, the ENTER PASSWORD box will be displayed again. [. . . ] `96H' + `04H' + connection ID (2 bytes) + `00H' + `00H' + `00H' + `00H' When the projector cannot execute the received command, the error code is sent back to the PC. `9FH' + `06H' + connection ID (2 bytes) + position number of projector having an error* (2 bytes) + group (1 byte) + ID (1 byte) + error code (2 bytes) *The position number is counted from the projector connected to PC directly, which has No. 1 as position number. Then, the next one is No. 2 and so on. Error Code Error Code Content 0 The command was not accepted, since the projector connected to PC was 1 busy. Communication error is happened between projectors. Set the communication Group identification and Communication ID Header + Command data (`02H' + `00H' + `00H' + `00H' + connection ID (2 bytes)) (1) Send the following setting code from the PC to the projector. [. . . ]