User manual HITACHI CP-X3011N

[. . . ] Projector CP-X2011N/CP-X2511N /CP-X3011N/CP-X4011N User's Manual (detailed) Operating Guide Thank you for purchasing this projector. WARNING Before using this product, please read all manuals for this product. Be sure to read "Safety Guide" first. After reading them, store them in a safe place for future reference. About this manual Various symbols are used in this manual. [. . . ] Some channel might be used for secondary language or empty. C. C. (Closed Caption) 49 OPTION menu OPTION menu From the OPTION menu, items shown in the table below can be performed. Select an item using the / cursor buttons, and press the cursor button or ENTER button to execute the item, except for the items LAMP TIME and FILTER TIME. Then perform it according to the following table. Item Description Using the / buttons turns on/off the automatic signal search function. ON OFF When the ON is selected, detecting no signal automatically cycles through input ports in the following order. The search is started from the current port. Then when an input is found, the projector will stop searching and display the image. COMPUTER IN1 COMPUTER IN2 LAN USB TYPE A VIDEO S-VIDEO COMPONENT HDMI USB TYPE B (Y, Cb/Pb, Cr/Pr) · It may take several seconds to project the images from the USB TYPE B port. Using the / buttons turns on/off the automatic keystone function. ON OFF ON : Automatic keystone distortion correction will be executed whenever changing the slant of the projector. Please execute the AUTO KEYSTONE (EXECUTE) in the SETUP menu for automatic keystone distortion correction. · When the projector is suspended from the ceiling this feature will not function properly so select the OFF. · This function will be unavailable when the Transition Detector is on ( 70). Using the / buttons turns on/off the DIRECT POWER ON function. ON OFF When set to the ON, the lamp in projector will be automatically turned on without the usual procedure ( 17), only when the projector is supplied with the power after the power was cut while the lamp was on. · This function does not work as long as the power has been supplied to the projector while the lamp is off. · After turning the lamp on by the DIRECT POWER ON function, if neither input nor operation is detected for about 30 minutes, the projector is turned off, even though the AUTO POWER OFF function ( 51) is disabled. AUTO SEARCH AUTO KEYSTONE DIRECT POWER ON (continued on next page) 50 OPTION menu Item Description Using the / buttons adjusts the time to count down to automatically turn the projector off. 0 minute = DISABLE) AUTO POWER OFF When the time is set to 0, the projector is not turned off automatically. When the time is set to 1 to 99, and when the passed time with nosignal or an unsuitable signal reaches at the set time, the projector lamp will be turned off. If one of the projector's buttons or the remote control buttons is pressed or one of the commands (except get commands) is transmitted to the CONTROL port during the corresponding time, projector will not be turned off. Please refer to the section "Turning off the power" ( 17). Using the / buttons selects the function of USB TYPE B port. [. . . ] Adjust BRIGHTNESS and/or CONTRAST settings to a higher level using the menu function. Set ECO MODE to NORMAL, and set AUTO ECO MODE to OFF, in the SETUP menu. The lamp is approaching the end of its product lifetime. Either the focus and/or horizontal phase settings are not properly adjusted. [. . . ]