User manual HITACHI CP-X400WF

[. . . ] Projector CP-X200/CP-X300/CP-X400 User's Manual (detailed) Operating Guide Thank you for purchasing this projector. WARNING Before using this product, please read all manuals for this product. Be sure to read "Safety Guide" first. After reading them, store them in a safe place for future reference. About this manual Various symbols are used in this manual. [. . . ] Select an item using the / cursor buttons, and press the cursor button or ENTER button to execute the item, except for the items LAMP TIME and FILTER TIME. Then perform it according to the following table. Item Description Using the / buttons turns on/off the automatic signal search function. TURN ON ó TURN OFF When the TURN ON is selected, detecting no signal automatically cycles through input ports in the following order. The search is started from the current port. Then when an input is found, the projector will stop searching and display the image. COMPUTER IN1 COMPUTER IN2 VIDEO S-VIDEO COMPONENT Using the / buttons turns on/off the automatic keystone function. TURN ON ó TURN OFF TURN ON : Automatic keystone distortion correction will be executed whenever changing the slant of the projector. Please execute the AUTO KEYSTONE EXECUTE in the SETUP Menu for automatic keystone distortion correction. · When the projector is suspended from the ceiling this feature will not function properly so select the TURN OFF. · This function will be unavailable when the Transition Detector is on (49). Using the / buttons turns on/off the AUTO ON function. TURN ON ó TURN OFF When set to the TURN ON, the lamp in projector will be automatically turned on without the usual procedure (15), only when the projector is supplied with the power after the power was cut while the lamp was on. · This function does not work as long as the power has been supplied to the projector while the lamp is off. · After turning the lamp on by the AUTO ON function, if neither input nor operation is detected for about 30 minutes, the projector is turned off, even though the AUTO OFF function (41) is disabled. AUTO SEARCH AUTO KEYSTONE AUTO ON (continued on next page) 40 OPTION Menu OPTION Menu (continued) Item Description Using the / buttons adjusts the time to count down to automatically turn the projector off. 0 minute = DISABLE) AUTO OFF When the time is set to 0, the projector is not turned off automatically. When the time is set to 1 to 99, and when the passed time with nosignal or an unsuitable signal reaches at the set time, the projector lamp will be turned off. If one of the projector's buttons or the remote control buttons is pressed or one of the commands (except get commands) is transmitted to the CONTROL port during the corresponding time, projector will not be turned off. Please refer to the section "Turning off the power" (15). The lamp time is the time counted after the last resetting. It is shown in OPTION menu as the usage time of the lamp. Pressing RESET button or the button displays a dialog. To reset the lamp time, select RESET using the button. [. . . ] Decreasing the projector setting value (Decrement command) () The PC sends the following decrement code to the projector. Header+Commanddata(`05H'+`00H'+type(2bytes)+`00H'+`00H') (2) The projector decreases the setting value on the above setting code. (3) The projector returns the response code `06H' to the PC. When the projector cannot understand the received command When the projector cannot understand the received command, the error code `15H' is sent back to the PC. [. . . ]