User manual HITACHI CP-X608

[. . . ] Projector CP-X608 User's Manual ­ Operating Guide Thank you for purchasing this projector. WARNING Before using this product, please read the "User's Manual Safety Guide" and related manuals to ensure the proper use of this product. After reading them, store them in a safe place for future reference. About this manual Various symbols are used in this manual. The meanings of these symbols are described below. [. . . ] This function should be used when the zoom adjustment is set to the full WIDE (wide-angle focus) whenever possible. · When the projector is placed on the level (about ±3°), this function may not work. · When the projector is inclined to near ±30 degree or over, this function may not work well. · When the vertical lens shift is not set fully upward (not set fully downward for the optional lens type FL-60 only (46)), this function may not work well. · When the horizontal lens shift is not set to the center, this function may not work well. · This function will be unavailable when the Transition Detector is on (52). Using the / buttons corrects the vertical keystone distortion. Shrink the top of the image ó Shrink the bottom of the image · The adjustable range of this function will vary among inputs. For some input, this function may not work well. · When the horizontal lens shift is not set to the center, this function may not work well. · This function will be unavailable when the Transition Detector is on (52). AUTO KEYSTONE EXECUTE KEYSTONE (continued on next page) 36 SETUP Menu SETUP Menu (continued) Item Description Using the / buttons corrects the horizontal keystone distortion. Shrink the right of the image ó Shrink the left of the image · The adjustable range of this function will vary among inputs. For some input, this function may not work well. · When the zoom adjustment is set to the TELE (telephoto focus), this function may be excessive. This function should be used when the zoom adjustment is set to the full WIDE (wide-angle focus) whenever possible. · When the vertical lens shift is not set fully upward (not set fully downward for the optional lens type FL-60 only (46)), this function may not work well. · This function will be unavailable when the Transition Detector is on (52). Using the / buttons turns off/on the whisper mode. NORMAL ó WHISPER · When the WHISPER is selected, acoustic noise and screen brightness are reduced. Using the / buttons switches the mode for mirror status. KEYSTONE WHISPER MIRROR NORMAL ó H:INVERT ó V:INVERT ó H&V:INVERT If the Transition Detector is TURN ON and MIRROR status is changed, Transition Detector Alarm (52) will be displayed when projector is restarted after the power switch is turned off. 37 AUDIO Menu AUDIO Menu From the AUDIO menu, items shown in the table below can be performed. Select an item using the / cursor buttons on the projector or remote control, and press the cursor button on the projector or remote control, or ENTER button on the remote control to execute the item. Then perform it according to the following table. [. . . ] Then, if the problem is not removed after the remedy, please contact your dealer or service company. . 3. Phenomenon Cases not involving a machine defect Reference page 3 7 The electrical power cord is not plugged in. Correctly connect the power cord. Power does not come on. The power switch is not set to the on position. The main power source has been interrupted during operation such as by a power outage (blackout), etc. Please turn the power off, and allow the projector to cool down at least minutes, then turn the power on again. 7 Either there is no lamp and/or lamp cover, or either of these has not been properly fixed. Please turn the power off, and allow the projector to cool down at least 45 minutes. [. . . ]