User manual HITACHI CPS220W

[. . . ] Liquid Crystal Projector ENGLISH CP-S220W USER'S MANUAL Thank you for purchasing this HITACHI liquid crystal projector. Please read the accompanying manual "SAFETY INSTRUCTIONS" and this "USER'S MANUAL" thoroughly to ensure correct usage through understanding. After reading, store this instruction manual in a safe place for future reference. NOTE: * The information in this manual is subject to change without notice. * The manufacturer assumes no responsibility for any errors that may appear in this manual * The reproduction, transmission or use of this documents or contents is not permitted without express written authority. TRADEMARK ACKNOWLEDGMENT: * PS/2, VGA and XGA are registered trademark of International Business Machines Corporation. [. . . ] Clear AUTO OFF: Select STOP (0 min. ) with the button. Wind Stop is selected the system does not enter the standby mode even if no signal is received. Operation start/stop: Press the or button. SYNC ON G valid: Select TURN ON with the button. SYNC ON G invalid: Select TURN OFF with the button. * When SYNC ON G is effective, it may not be displayed normally by an input signal. Remove a signal connector, and make it condition without a signal, and input a signal again in this case SYNC ON G after it is overridden. SYNC ON G 1-14 OPERATIONS (continued) The same adjustments and settings are available as with the Image and Options menus when the MENUO button is pressed during display of the `NO INPUT IS DETECTED ON ***' or `SYNC IS OUT OF RANGE ON ***' message while no signal is received. See Table 1. 7 below. VOLUME KEYSTONE BLANK MIRROR START UP MENU COLOR TIMER LANGUAGE AUTO OFF SYNC ON G 40 +1 Table 1. 7 No Signal Menu Item VOLUME KEYSTONE Description Increase VOLUME Volume adjustment: Reduce VOLUME Adjustment: Reduce size of bottom of image Reduce size of top of image BLANK Select blank screen color: Select color with the and buttons. * The image is cleared when the BLANK MODE is set with BLANK ON, or when there is no signal, and the entire screen is displayed in the selected color. Note that if TURN OFF is selected on the START UP the blank screen is displayed in blue when there is no signal. Operation start/stop: Press the or button. Select Mirror status: Select mirror status with and MIRROR buttons. START UP Operation start/stop: Press the or button. Setup initial screen display: Select TURN ON with the button. Clear initial screen display: Select TURN OFF with the button. * Note that if TURN OFF is selected the blank screen is displayed in blue when there is no signal. Select menu background color: Select with the Operation start/stop: Press the or button. Setup initial timer value: Set 1~99 minutes with the Operation start/stop: Press the or button. Select menu display language: Select with the and and and buttons. buttons. MENU COLOR TIMER LANGUAGE AUTO OFF Operation start/stop: Press the or button. Set AUTO OFF: Set 0~99 minutes with the and buttons. The system automatically enters the standby mode when a signal is not received for the set time. Clear AUTO OFF: Select STOP (0 min. ) with the button. [. . . ] 3. 0Vp-p) Stereo mini jack (Speaker output is L/R mixed. ) D-sub 15-pin shrink jack 1-22 SPECIFCATIONS (continued) ENGLISH 289 45. 6 74. 5 76 Unit : mm Dimension Diagram WARRANTY AND AFTER-SERVICE A warranty is provided for this product. Fill in the necessary items and store in a safe place. * When a problem occurs, please check first using the Troubleshooting Chart provided in this instruction manual. If the problem still persists, contact your dealer or service company. [. . . ]