User manual HITACHI CP-S310

[. . . ] Liquid Crystal Projector ENGLISH USER'S MANUAL Thank you for purchasing this liquid crystal projector. Please read the accompanying manual "SAFETY INSTRUCTIONS" and this "USER'S MANUAL" thoroughly to ensure correct usage through understanding. After reading, store this instruction manual in a safe place for future reference. NOTE: · The information in this manual is subject to change without notice. · The manufacturer assumes no responsibility for any errors that may appear in this manual · The reproduction, transmission or use of this document or contents is not permitted without express written authority. TRADEMARK ACKNOWLEDGMENT: · PS/2, VGA and XGA are registered trademarks of International Business Machines Corporation. [. . . ] Select NTSC, PAL, SECAM, NTSC4. 43, M-PAL, or N-PAL as appropriate for the input signal. Auto Adjust is valid at VIDEO/S-VIDEO input when AUTO is selected, and is then used for automatic selection of the signal type. · Use this function when the image becomes unstable (eg. the image becomes irregular, or lacks color). · Auto Adjust requires approximately ten seconds. It may not function correctly with some input signals. Pressing the AUTO button in this case may correct this problem. Automatic adjustment at RGB input: Select EXECUTE with the button. Horizontal position, vertical position, clock phase, and horizontal size are automatically adjusted when EXECUTE is selected. Use with the window at maximum size in the application display. Automatic adjustment at VIDEO/S-VIDEO input: Select EXECUTE with the button. A signal type appropriate for the input signal is selected automatically when EXECUTE is selected. Valid only if AUTO is selected in VIDEO (see above). · This operation requires approximately ten seconds. It may not function correctly with some input signals. Pressing the AUTO button in this case may correct this problem. · This function is the same as for Auto Adjust in Basic operation. VIDEO AUTO ENGLISH-13 ENGLISH Input Menu OPERATIONS (continued) Image Menu The following adjustments and settings are available when IMAGE is selected on the menu. Select an item with the and buttons, and start operation. SETUP INPUT IMAGE OPT. +1 KEYSTONE BLANK MIRROR START UP Table 5. Image Menu Item Description Adjustment: Reduce size of bottom of image Reduce size of top of image KEYSTONE · When this function is activated, the image may not be displayed correctly with some input signals. BLANK Select blank screen color: Select color with the and buttons. · The image is cleared when the BLANK mode is set with BLANK ON, or when there is no signal, and the entire screen is displayed in the selected color. [. . . ] Contact your dealer if the same problem occurs again. Lights red Lights red Blinks red Lights red Turns off Lights red Turns off Lights red *1) When the internal temperature becomes excessive power is switched OFF automatically for safety reasons, and the indicator is extinguished. Set the power switch to [O] and wait for 20 minutes until the equipment has cooled sufficiently. ENGLISH-21 ENGLISH Indicators Message TROUBLESHOOTING (continued) Symptom Before requesting repair, check in accordance with the following chart. If the situation cannot be corrected, then contact your dealer. Table 10. Symptom Symptom The power is not turned on. Possible cause The main power switch is not turned on. [. . . ]