User manual HITACHI CP-X505

[. . . ] Projector CP-X505/CP-X605 User's Manual ­ Operating Guide Thank you for purchasing this projector. WARNING Before using this product, please read the "User's Manual Safety Guide" and related manuals to ensure the proper use of this product. After reading them, store them in a safe place for future reference. About this manual Various symbols are used in this manual. The meanings of these symbols are described below. [. . . ] Projector automatically corrects vertical keystone distortion due to the (forward/backward) setup angle by itself. This function will be executed only once when selected in the Menu. When the slant of the projector is changed, executes this function again. · The adjustable range of this function will vary among inputs. For some input, this function may not work well. · When V:INVERT or H&V:INVERT is selected to the MIRROR item in the SETUP menu, if the projector screen is inclined or angled downward, this function may not work correctly. · When the zoom adjustment is set to the TELE (telephoto focus), this function may be excessive. This function should be used when the zoom adjustment is set to the full WIDE (wide-angle focus) whenever possible. · When the projector is placed on the level (about ±3°), this function may not work. · When the projector is inclined to near ±30 degree or over, this function may not work well. · When the vertical lens shift is not set fully upward (not set fully downward for the optional lens type FL-60 only (45)), this function may not work well. · When the horizontal lens shift is not set to the center, this function may not work well. · This function will be unavailable when the Transition Detector is on (51). Using the / buttons corrects the vertical keystone distortion. Shrink the top of the image ó Shrink the bottom of the image · The adjustable range of this function will vary among inputs. For some input, this function may not work well. · When the vertical lens shift is not set fully upward (not set fully downward for the optional lens type FL-60 only (45)), this function may not work well. · When the horizontal lens shift is not set to the center, this function may not work well. · This function will be unavailable when the Transition Detector is on (51). Using the / buttons corrects the horizontal keystone distortion. Shrink the right of the image ó Shrink the left of the image · The adjustable range of this function will vary among inputs. For some input, this function may not work well. [. . . ] Please push the Shutdown switch by using a pin or similar and the projector will be turned off immediately. Before turning it again, wait at least 0 minutes to make the projector cool down enough. Please use the FACTORY RESET function of the SERVICE item in the OPTION menu (46) to reset all settings to factory default. Then, if the problem is not removed after the remedy, please contact your dealer or service company. . [. . . ]