User manual HITACHI CP-X600

[. . . ] Projector CP-X600 User's Manual ­ Operating Guide Thank you for purchasing this projector. WARNING Before using this product, please read the "User's Manual Safety Guide" and related manuals to ensure the proper use of this product. After reading them, store them in a safe place for future reference. About this manual Various symbols are used in this manual. The meanings of these symbols are described below. [. . . ] (2) Using the / buttons switches the mode for video format. AUTO ó NTSC ó PAL ó SECAM N-PAL ó M-PAL ó NTSC4. 43 · This item is performed only for a video signal from the VIDEO port or the S-VIDEO port. · The AUTO mode automatically selects the optimum mode. · The AUTO operation may not work well for some signals. an irregular picture, lack of color), please select the mode according to the input signal. (continued on next page) 3 INPUT Menu INPUT Menu (continued) Item Description Using the / buttons turns the frame lock function on/off. TURN ON ó TURN OFF · This item can be performed only on an RGB signal with a vertical frequency of 50 to 60 Hz. · When the TURN ON is selected, a moving pictures are displayed more smoothly. · This function may cause a certain degradation of the picture. In such a case, please select the TURN OFF. Set the RGB input signal type for the RGB port. () Use the / buttons to select the RGB port to be set. RGB ó RGB (2) Use the / buttons to select the RGB input signal type. SYNC ON G ON ó SYNC ON G OFF · Selecting the SYNC ON G ON turns the SYNC ON G mode on. The SYNC ON G mode allows reception of a sync on G signal. · In the SYNC ON G mode, the picture may be distorted with certain input signals. In such a case, remove the signal connector so that no signal is received and turn the SYNC ON G mode off, and then reconnect the signal. FRAME LOCK RGB IN (continued on next page) 3 INPUT Menu INPUT Menu (continued) Item Description The resolution for the RGB and RGB input signals can be set on this projector. (1) In the INPUT menu select the RESOLUTION using the / buttons and press the button. () In the RESOLUTION menu select the resolution you wish to display using the / buttons. Selecting AUTO will set a resolution appropriate to the input signal. (3) Pressing the or ENTER button when selecting a STANDARD resolution will automatically adjust the horizontal and vertical positions, clock phase and horizontal size and automatically select an aspect ratio. The INFORMATION dialog (45) will be displayed. (4) To set a custom resolution use the / buttons to select the CUSTOM and the CUSTOM RESOLUTION BOX will be displayed. Set the horizontal (HORZ) and vertical (VERT) resolutions using the // / buttons. [. . . ] Please push the Shutdown switch by using a pin or similar and the projector will be turned off immediately. Before turning it again, wait at least 0 minutes to make the projector cool down enough. Please use the FACTORY RESET function of the SERVICE item in the OPTION menu (45) to reset all settings to factory default. Then, if the problem is not removed after the remedy, please contact your dealer or service company. . [. . . ]