User manual HITACHI CV-90CY_BS_RBL

[. . . ] (C) Low position: For reaching under low furniture to raise the front of the nozzle head to clear steps. Fig. 5 NOTE: The handle should always be in upright position when cleaning tools are used. -2- AUTOMATIC HEIGHT CONTROL (Fig. 6) The HITACHI vacuum cleaner has an automatic height control, which adjusts the nozzle to the proper height of any carpet pile. Fig. 6 DUST COMPARTMENT OPERATION (Fig. 7) When the orange sign 6 appears continuously in the window, empty the dust compartment. Never allow the dust compartment to become so full that the dirt will block the passage to the compartment. [. . . ] 3) Be careful when removing the dust compartment not to spill dust. 4) Put the whole dust compartment into a poly bag and press the open button to empty dust into the poly bag. 5) Turn the dust compartment downwards, push the open button for the lid of the dust compartment, to release the dust. 6) Remove dust around the mesh filter and under mesh filter. Filter care (Fig. 18) It is recommended that the filter is cleaned once or twice a month to ensure optimum suction power: 1) Empty the dust compartment as described in the previous section. 2) Take off the filter supporter from the filter holder. 3) Wash the filter in tepid water or a neutral detergent. If detergent is used, rinse it out thoroughly. NOTE: Filter Supporter Filter Filter Holder 1) Don't wash in boiling water or in a washing machine. 2) Don't dry over a fire, in hot sunlight or in a tumble dryer. 3) If the filter is used when wet, suction will be impaired and the motor may be damaged. Fig. 18 -6- *Filters in dust case (Washable) (Maintenance once a month) (Fig. 19) 1) Remove the dust compartment and empty out the dust. Remove the cyclone case by pushing the button with two fingers (the forefinger and the middle finger). Remove the dust around the inside mesh filter ( the mesh filter is washable). 3) Open the lid of the dust compartment and remove the mesh filter, you can wash the mesh filter. 4) Turn the lid of dust compartment to its original position, close it with a click and 5) Install the dust compartment into the cleaner body. NOTE: Fit each filter in position correctly, if not, dust will be spilled which will clog the filters resulting in a reduction of suction power. Button Cyclone case Inside mesh filter Fig. 19 *Black filter (Washable) (Fig. 19) After removing dust compartment, pull the middle knob and remove Black filter. Remove dust from the Black filter, and install it to correct position. *HEPA clean filter (Fig. 20) 1) Open the front cover while taking off the hook right side of the cover. You can see HEPA clean filter and lower filter inside. Remove the HEPA clean filter by pulling the handle on the filter. [. . . ] IMPORTANT The wires in the mains lead are coloured in accordance with the following code: Blue=Neutral, Brown=Live As these colours may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire coloured BLUE must be connected to the terminal marked with the letter N or coloured BLUE or BLACK. The wire coloured BROWN must be connected to the terminal marked with the letter L or coloured BROWN or RED. On no account connect either of these wires to the terminal marked E or by the earth symbol or coloured green or green and yellow. THIS PRODUCT CONFORMS WITH THE REQUIREMENTS OF THE FOLLOWING COUNCIL DIRECTIVES: EMC: 89/336/EEC. LVD: 72/33/EEC, AND MARKING 93/68/EEC. -10- Hitachi, Ltd. [. . . ]