User manual HITACHI ED-X12F

[. . . ] Projector ED-X10/ED-X12 User's Manual ­ Operating Guide Thank you for purchasing this projector. WARNING Before using this product, please read the "User's Manual Safety Guide" and related manuals to ensure the proper use of this product. After reading them, store them in a safe place for future reference. About this manual Various symbols are used in this manual. The meanings of these symbols are described below. [. . . ] · When vertical degree is over ±30 degree, the automatic keystone distortion correction may not work well. · This function will be unavailable when Transition Detector is on ( 48). Upper in the data Lower in the data · The adjustable range of this function will vary with the type of input signal. At some signals, this function may not work well. · This function will be unavailable when Transition Detector is on ( 48). BRIGHT NORMAL · When the NORMAL is selected, acoustic noise and screen brightness are reduced. AUTO KEYSTONE EXECUTE KEYSTONE WHISPER 35 SETUP Menu SETUP Menu (continued) Item Description MIRROR NORMAL H:INVERT V:INVERT If Transition Detector is TURN ON and MIRROR status is changed, Transition Detector Alarm ( 48) will be displayed when projector is restarted after the power switch is turned off. VOLUME High Low Allocates the audio ports. Choose a picture input port using the buttons AUDIO interlocked with the input port using the audio ports do not work for the input port. (1) RGB1 RGB2 COMPONENT S-VIDEO (2) 1 2 3 VIDEO 36 SCREEN Menu SCREEN Menu With the SCREEN menu, the items shown in the table below can be performed. on the projector or remote control, or the ENTER button on the remote control to execute the item. Then perform it referring to the following table. Item language. ENGLISH FRANÇAIS NORSK DEUTSCH ESPAÑOL PORTUGUÊS SVENSKA SUOMI POLSKI TÜRKÇE ITALIANO Description LANGUAGE NEDERLANDS MENU POSITION To quit the operation, press the MENU button on the remote control or keep no operation for about 10 seconds. The blank screen is a screen for the temporarily blanking feature ( 22). It is displayed by pressing the BLANK button on the remote control. MyScreen ORIGINAL BLUE WHITE BLACK BLANK MyScreen is a screen you can register as a desired screen. The ORIGINAL screen is the existing standard screen. BLUE, WHITE and BLACK are non-patterned (plain) screens in each color. · To avoid remaining as an afterimage, the MyScreen and the ORIGINAL screens will change to the BLACK screen after several minutes. · For the MyScreen, please refer to the MyScreen item ( 38). 37 SCREEN Menu SCREEN Menu (continued) Item Description The start-up screen is a screen displayed when no signal or an unsuitable signal is detected. MyScreen ORIGINAL TURN OFF MyScreen is a screen you can register as a desired screen. The ORIGINAL screen is the existing standard screen. When TURN OFF is selected, the BLACK screen is used. · To avoid remaining as an afterimage, the MyScreen and the ORIGINAL screens will change to the BLANK screen after several minutes. If also the BLANK screen is the MyScreen or ORIGINAL, it will change to the BLACK screen. · For the MyScreen, please refer to the item MyScreen below. [. . . ] (2) The projector in creases the setting value on the above setting code. (3) The projector returns the response code `06H' to the computer. Decreasing the projector setting value (Decrement command) (1) The computer sends the decrement code Header + Command data (`05H'+ `00H'+ type (2 bytes) +`00H' + `00H') to the projector. (2) The projector decreases the setting value on the above setting code. [. . . ]