User manual HITACHI PDV314

[. . . ] PORTABLE DVD PLAYER WITH TWIN 7" SCREENS PDV314 Instruction Manual REGION 2 Before operating please read all these instructions thoroughly. SOME DOS AND DON'TS ON THE SAFE USE OF EQUIPMENT This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. ************** DO DO read the operating instructions before you attempt to use the equipment. ensure that all electrical connections (including the mains plug, extension leads and inter-connections between the pieces of equipment) are properly made and in accordance with the manufacturer's instructions. Switch off and withdraw the mains plug before making or changing connections. consult your dealer if you are ever in doubt about the installation, operation or safety of your equipment. [. . . ] Operation angle : about + / - 30 degree in each the direction of the front of the IR sensor. Usage of Adapter 1. The player is supplied with an AC/DC adapter. Connect the AC/DC adapter to the DC power in jack at the side of the DVD player. Plug the AC/DC adapter into a household power outlet. - 14 - BASIC SET-UP Install / Detach the Battery Pack 1. Follow the illustrations to install the battery pack. Press the release button at the right side of battery pack, follow the direction to uninstall the battery pack from the unit. Using the Rechargeable Ni-MH Battery Pack 1. Connect the AC/DC adapter lead to the unit and plug the AC adapter into a mains socket. Switch off the unit by sliding the ON/OFF button to OFF. The battery will start to charging automatically, at this moment, the charging LED will light in red. When the charge LED blink in green, charging is completed. Notes: 1. Charge the battery pack before using it for the first time. Charge time is normally between 3~4 hours. Battery pack should be fully charged before use. Charge only with the supplied AC/DC adapter. Do not charge for more than 4 hours as it could reduce service life. When playing the unit in conjunction with the battery pack and battery low displays, this indicates that battery power is low and the battery should be recharged. When the battery pack is being charged, the CHARGE LED will light in red, when charging is completed, the LED will blink in green. When the unit is simultaneously connected to the battery pack and AC adapter, the unit will automatically select the AC adapter as its power source. Remove the battery pack to avoid leakage if you do not use your set for more than one month. In case the charge LED does not light, please check that the battery connection is correct or not. In case the charge is failing and out of time, the charge LED will blink in green and red. Playback Preparation / Quick Operation Guide 1. Connecting to power ( AC/DC adapter, external DC power source through Cigarette connector cable or with attached battery pack ). [. . . ] · Reset by unplugging the player from the power supply, then connect the power supply again. THE PLAYER DOES NOT RESPOND TO THE REMOTE CONTROL · Aim the remote control directly at the sensor on the front of the player. · Avoid all obstacles which may interfere with the signal path. · Inspect or replace the batteries (Lithium battery "CR2025"). NO AUDIO AT DIGITAL OUTPUT · Check the digital connections. · Check the Digital Out menu to make sure that the digital output is correctly set. [. . . ]