User manual HITACHI TRAVELSTAR Z5K320 QUICK INSTALL GUIDE

[. . . ] Quick Installation Guide Hitachi Travelstar Z5K320 7mm z-height Hard Disk Drive Models: HTS543232A7A384 HTS543225A7A384 HTS543216A7A384 HTS543232A7A385 HTS543225A7A385 HTS543216A7A385 HTE543232A7A384 HTE543225A7A384 Handling precautions Set the drive down gently to prevent damage from impact or vibration. Handle the drive carefully by the edges. [. . . ] Performance and error rate will stay within specification limits if the drive is operated in the other permissible orientations from which it was formatted. Thus a drive formatted in a horizontal orientation will be able to run vertically and vice versa. The recommended mounting screw torque is 0. 3±0. 05 Nm. The recommended mounting screw depth is 3. 0±0. 3 mm for bottom and 3. 5±0. 5 mm for horizontal mounting. The user is responsible for using the appropriate screws or equivalent mounting hardware to mount the drive securely enough to prevent excessive motion or vibration of the drive at seek operation or spindle rotation. Interface connector The figure below shows the physical pin location All pins are in a single row, with a 127 mm (0. 050") pitch. The comments on the mating sequence in Table in the section 7. 3 apply to the case of back-plane blind-mate connector only. In this case, the mating sequences are:(1) the ground pins P4 and P12;(2) the pre-charge power pins and the other ground pins; and (3) the signal pins and the rest of the power pins. Page 3 version 1. 0 Hitachi Global Storage Technologies There are three power pins for each voltage. One pin from each voltage is used for pre-charge in the backplane blind-mate situation. All V5 pins must be terminated. © 2010 Hitachi Global Storage Technologies Produced in the United States 6/10 All rights reserved Travelstar is a trademark of Hitachi Global Storage Technologies. Hitachi and Hitachi Inspire the Next logo are trademarks of Hitachi, Ltd in the U. S. , Japan and/or other countries. Hitachi Global Storage Technologies' trademarks are authorized for use in countries and jurisdictions in which Hitachi has the right to use, market and advertise the brands. The Travelstar trademark is authorized for use in the Americas, EMEA and the following Asia-Pacific countries and jurisdictions: Australia, Hong Kong, Japan, New Zealand, South Korea and Taiwan. Contact Hitachi for further information. [. . . ] Actual specifications for unique part numbers may vary. Please visit the Support section of our website, www. hitachigst. com/support, for additional information on product specifications. [. . . ]