User manual HITACHI ULTRASTAR 15K73 QUICK INSTALLATION GUIDE

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual HITACHI ULTRASTAR 15K73. We hope that this HITACHI ULTRASTAR 15K73 user guide will be useful to you.

Lastmanuals help download the user guide HITACHI ULTRASTAR 15K73.

Download

You may also download the following manuals related to this product:

HITACHI ULTRASTAR 15K73 DATASHEET (241 ko)

Manual abstract: user guide HITACHI ULTRASTAR 15K73QUICK INSTALLATION GUIDE

Detailed instructions for use are in the User's Guide.

 [. . . ] Quick installation guide

Hitachi Ultrastar 15K73
Ultra320 SCSI Hard disk drive
Model Numbers: 68 Pin Interface: 80 Pin Interface:
SPECIFICATIONS Formatted Capacity*(Gbytes) Bytes per Sector* #Cylinders/#Heads/#Disks Maximum LBA*(Hex) Seektime:Average(Read.  [. . . ] Keep the original packaging and static-protective bag in case the drive has to be returned. Installation horizontal or vertical ( 6 directions) 2. Provide adequate air flow to cool drive 3. Maximum screw penetration 3. 8mm (0. 15 in) into drive Cable Specifications: 1. Use interface cables that meet the ANSI SCSI guideline. Cable length: Interface cable (NW,  Single-ended mode) Cable Type SCSI Interface DC power supply
7/28/2003 v1. 0

Flat Ribbon or Twisted Pair AWG#20

Maximum cable length Fast-5 Fast-10 6m 3m (16 units max. ) (16 units max. ) 3m

Ultra(Fast20) 3m(4 units max. ) 1. 5m (8 units max. )

1

Interface cable (NW,  LVD mode) Cable Type SCSI Interface DC power supply Connector Layout: Flat Ribbon or Twisted Pair AWG#20 Maximum cable length Ultra2(Fast)-40, Ultra160(Fast-80), Ultra 320(Fast-160) 12m (16 units max. ) 3m

Wide LVD 68pin-16bits (NW)

SCA-2 LVD 80 pin-16bits (NC)

Option Jumper Connector C3 NW Pin Function Removed
1-2 7/28/2003 v1. 0 ID3 *

Installed

Function
ID3

NC Removed
*

Installed

2

3-4 5-6 7-8 9-10 11-12 13-14 15-16 17-18 19-20 21-22 23-24

ID2 ID1 ID0 Disable Auto Start Force SE bus mode Enable delay start Write Protect Reserved Reserved LED(with 0 Ohm) Term Power

* * * At power on per C3 pins 13-14 Single-ended or LVD mode* At power on* Write Enable*

Only by SCSI Command Only by SCSI Command In 10 sec x ID intervals on power on Write Protected

ID2 ID1 ID0 Disable Auto Start Force SE bus mode Enable delay start Write Protect Reserved Reserved LED(with 0 Ohm) Term Power

* * * Refer note3 below Single-ended or LVD mode* At power on* Write Enable*

Only by SCSI Command Only by SCSI Command In 10 sec x ID intervals on power on Write Protected

Termpwr not to SCSI Bus*

Termpwr to SCSI bus

Termpwr not to SCSI Bus*

Termpwr to SCSI bus

·

Indicates Default Settings. Spare jumpers C3: 2-4,  6-8,  12-14-16, 18-20 for NW model,  C3: 18-20 for NC model. . These spare jumpers can be used for another setting. 

7/28/2003 v1. 0

3

© Copyright Hitachi Global Storage Technologies Hitachi Global Storage Technologies 5600 Cottle Road San Jose,  CA 95193 Produced in the United States 7/03 All rights reserved TravelstarTM is a trademark of Hitachi Global Storage Technologies.  [. . . ] This publication is for general guidance only.  [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE HITACHI ULTRASTAR 15K73

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual HITACHI ULTRASTAR 15K73 will begin.