User manual HITACHI ULTRASTAR 9LP QUICK INSTALLATION GUIDE

[. . . ] Each drive on the SCSI bus must have a unique address. Sixty-eight and eighty-pin (Wide SCSI) devices have 16 possible addresses. SCSI address bits 3 (68- & 80-pin models only), 2, 1, and 0 of the 32-pin Option Jumper Block are used to select the SCSI device ID. Power Pin 1 Aux Connector Pin 1 SCSI Pin 1 2. [. . . ] The warranty will be void if the drive is not returned in IBM approved packaging. :::::: Pin 35 Pin 2 Reserved Auto Start Blank GD N SCSI Address Bit 32 1 0 External Activity LED Write Protect Autostart Delay Force Single Ended Mode Disable Sync Negotiations Disable SCSI Parity Disable Unit Attention Disable Wide Negotiations 1357 11 13 15 17 19 21 23 25 27 29 31 1 2 2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 GD N Reserved Reserved Reserved +5V GD N Termination Power Enable Page 1 IBM Hard Disk Drive Technical Support Center version 2. 0 IBM storage products Note In the table below, "off" means a jumper is not in place and "on" means a jumper is in place. Bit 3 off off off off off off off off on on on on on on on on Bit 2 off off off off on on on on off off off off on on on on Bit 1 off off on on off off on on off off on on off off on on Bit 0 off on off on off on off on off on off on off on off on Address 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 [ENTER]. The /S parameter makes C: the operating system startup drive. To format a second drive (not C:), type FORMAT X: (where X is the drive letter assigned by FDISK) at the DOS prompt and press [ENTER] 4. Remove the diskette and restart your computer. If your system will not boot up after complete installation, recheck all settings. If the system still fails to boot up, remove the new drive to return the system to its original configuration and call the IBM Hard Disk Drive Technical Support Center. ® © International Business Machines Corporation 1999 Attaching the drive 1. Turn off the computer, unplug the power cord and open the case. If the DGHS drive is the only device on the SCSI cable, attach it to the end of the cable furthest from the controller. (Note that the using system is responsible for making sure that all required signals are terminated at both ends of the cable. ) 3. Select the other option jumpers as required by your computer. Mount the drive securely, using the appropriate brackets or rails, in any axes, using four 6-32 UNC metric screws in the bottom or side mounting holes. The maximum screw insertion depth for mounting is 3. 8 mm (. 15 in). Plug in the power cord, insert the System Diskette and power on your computer. Your computer may detect a configuration change and prompt you to proceed to the Setup screen. If your computer does not prompt you to enter reconfiguration, enter your computer's Setup, typically by key selection or keyboard combinations during power-on or during a reboot. Refer to your computer's documentation for the proper key sequence. [. . . ] Produced by the IBM Hard Disk Drive Technical Support Center. Ultrastar 18XP/9LP Hardware/Functional Specification, version 4. 50 Ultrastar 18XP/9LP Parallel SCSI Disk Drive Logical Interface Specification, version 6. 0 Ultrastar 18XP/9LP Parallel SCSI Disk Drive Logical Interface Specification addendum, version 6. 0 Product Description data represents IBM's design objectives and is provided for comparative purposes; actual results may vary based on a variety of factors. This product data does not constitute a warranty. [. . . ]