User manual HITACHI VTF350EUKN

[. . . ] 1994 Printed in Malaysia HITACHI SALES CORPORATION OF HAWAII, INC. HITACHI CANADA 3300 Trans VHS 3219 Koapaka Street Honolulu, HI 96819 Tel. 514-697- 1 TABLE OF CONTENTS TABLE OF CONTENTS FOR YOUR SAFETY. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Read This First . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Press STOP/EJECT on the VCR to release the tape. Movie Return If your videocassette has the safety tab removed and you set the MOVIE functions to ON during initial setup, the VCR will stop and automatically rewind the videocassette, eject it, and turn off the power when it reaches the end of the tape or a blank section of tape which lasts for more than 30 seconds. This function works only in PLAYBACK mode, not in RECORDING mode. Special Playback Effects Still Playback (Pause) Press PAUSE to still the tape during play. You may see some minor noise or interference on the screen. After 5 minutes in PAUSE mode, the VCR automatically switches to STOP mode to protect the tape. If noise bars appear on the TV screen during PAUSE mode, first set the VCR to SLOW mode and then press the 1 or 4 button on the remote control to minimize the noise bars. If the screen jitters during PAUSE, press either 1 or 4 button to minimize it. To resume play, press PLAY or PAUSE again. Frame Advance While in PAUSE mode during playback, press 9 button to view the video one frame at a time. Skip Playback While playing back your tape you can skip forward by pressing the 9 button. Pressing DISPLAY will cycle you through the three options. Press DISPLAY just once to see the counter, mode, time, and date on the screen for 5 seconds. 27 Basic Operations Before the 5 seconds is up, press DISPLAY a second time to see just the counter. Press DISPLAY a third time to to see the counter on the VCR display as well. Press DISPLAY a fourth time to end the on-screen display. The linear time counter operates only if there is something recorded on the tape. The counter changes to 0:00:00 when the tape is ejected. Marking with the Time Counter If there is one part of the video that you know you are going to want to return to, you can set the time counter to memorize that spot. Press DISPLAY twice to show the counter on the TV screen. Notice the counter remains on the screen. At the point that you want to go back to, press CLEAR. Press STOP when you are done recording or playing back the tape. [. . . ] The exposed uninsulated voltage in this unit may be high enough to cause electrical shock. It is dangerous to make contact with any inside part, and none of these parts are intended to be serviced by an untrained user. To be safe, refer service problems to 49 VCR Care and Servicing qualified service personnel. Technical Specifications Format: VHS Video Signal System: NTSC color EIA standard Record/Playback System: Video: 4 heads Audio: VHS Hi-Fi stereo record / playback system Tape Speed: 33. 35mm / sec (SP), 16. 67mm / sec (LP) (playback only) 11. 12mm / sec (EP) RF Input: UHF/VHF 75 ohm Tuner: USA : 181 channel tuning capability* (125 cable channels) Canada : 178 channel tuning capability* (122 cable channels) Type: Auto programming frequency synthesis Power Input: AC120V 60Hz Power Consumption: 22W nominal Cabinet Size: 14-15/16" (W) x 3-11/16" (H) x 12-5/8" (D) 38. 0cm (W) x 9. 3cm (H) x 32. 0cm (D) Weight: 9. 9 lbs. (4. 5kg) Storage Temperature: -4º F to 131º F Operating Temperature: 41º F to 104º F Accessories: 1 coaxial cable (Part No. [. . . ]