User manual HITEC HTS-SS INSTALLATION

[. . . ] HTS-SS 2. 4Gz Telemetry Product Installation Guide Introduction Beginning with the Ver. 1. 07 software Aurora transmitters will be fully capable of advanced 2. 4G downlink data telemetry. When using a combination of sensors and Hitecs micro "Sensor Station", all of the following functions can be displayed on the Aurora screen during the ight, and viewed on a PC in real time!On-Board Battery Voltage, (this is displayed without the use of sensors when the Auroras SPC function is used). [. . . ] Repeat this process for the other temp sensors used. g. To view the minimum, average and maximum temp readings for any of your installed temp sensors, note the numbers when any one of the sensors is selected on the screen. Exit this screen using the door icon in the upper left of the screen. To view all the sensor data in real time, press Cockpit B. For prop driven aircraft, use double sided tape to attach the sensor in the airfame with the front of the sensor aimed at the revolving propeller. 5. RPM Sensor There are two di erent RPM sensors available for use on the Hitec telemetry system. Optical RPM Sensor (HTS-ORPM) - provides RPM information using a optic sensor. This is used for outdoor heli head speed and prop plane RPM values. Indoor lighting and outdoor lighting variations can a ect the readings of the optic sensor. Note Magnetic Sensor Installation A. The magnetic sensor consists of two main parts, the sensor and magnet. Three small magnets are supplied with the unit. The typical installation will have the sensor mounted on the motor mount or airframe, and one magnet attached to the spinner backing plate or prop hub in such a way as to "trigger" a signal every time the rotating magnet passes in front of the stationary sensor. It is suggested a small hole be drilled in the spinner backing plate, or prop hub into which one of the magnets is set ush using hobby CA. Note the tolerances here are very tight, the distance between the sensor and spinning magnet need to be 1mm. Each magnet has a X mark to identify polarity, please make sure the X mark to be faced out. Otherwise the sensor cannot detect the magnet. Magnetic RPM Sensor (HTS-MRPM) - provides RPM information using a magnetic sensor. This is used for aircraft with propellers, ducted fans, heli tail rotors and main gears. The edit function as described at the end of this document in the HPP-22 data display. To use the Magnetic sensor with heli main gear / head speed ratios Note There are two slots in the Sensor Station for RPM sensors. Any combination of optical or magnetic sensors can be used. 6 Note HTS-SS 2. 4Gz Telemetry Product Installation Guide 5. [. . . ] Along with this information is other pertinent data, GPS strength bars, date, time, altitude and speed are available. To change the date, Unit of measurement and to select ABSOLUTE, (above-groundlevel) or RELATIVE, (above sea level) altitude values, press the Setting icon 2. 4Gz Telemetry Product Installation Guide 8. Under the Product menu, select "etc" 8. As the target select SPECTRA 2. 4 Module HTS-SS 9. [. . . ]