User manual HOLMES HAOF1233

[. . . ] 8) DO NOT operate any appliance with a damaged cord or plug, if motor fan fails to rotate, after the appliance malfunctions, or if it has been dropped or damaged in any manner. Return appliance to manufacturer for examination, electrical or mechanical adjustment, or repair. 9) DO NOT operate in the presence of explosive and/or flammable fumes. 10) Use appliance only for intended household use as described in this manual. [. . . ] Step 6: Align the metal plate with the indentation on the bottom of the grill ring. Pass the screw with the washer through the opening on the bottom of the grill ring and fasten to the metal plate. ILLUSTRATION M N O CLEANING/MAINTENANCE Follow these instructions to correctly and safely care for your Holmes table fan. Please remember: · Always unplug the fan before cleaning or disassembling. · Do not allow water to drip on or into the fan motor housing. · Do not use any of the following as a cleaner: gasoline, thinner, benzine (See instructions for fan head assembly) Step 1: To access the fan blade, remove the front grill and the fan blade nut. Step 2: Clean the fan blade, both front and rear grills with a soft cloth moistened with a mild soap solution. Step 3: Replace blade, tighten the fan blade nut, and securely fasten the front grill. Fan Head and Base Cleaning Using a soft, moist cloth, with or without a mild soap solution, carefully clean the fan base and head. Please use caution around the motor housing area. Do not allow the motor or other electrical components to be exposed to water. A B C E D KL F G H I J Q P A. S. Motor Housing Pole Speed Control Lever Base Base Nut OPERATING INSTRUCTIONS Step 1: Set the fan base on a dry, level surface. Step 2: Please make sure the On/Speed lever is in the "Off" position. Plug the cord into any standard 120-volt A/C outlet. Step 3: The SPEED is adjusted by moving the lever up or down to the desired setting. Step 4: The OSCILLATION control knob is located on the top of the fan motor housing. To start oscillation, push control knob down. To stop oscillation, pull control knob up. FAN STORAGE Your fan can be stored in the off-season either partially disassembled or assembled. It is important to keep it in a safe, dry location. · If stored disassembled, we recommend using the original (or appropriately sized) box. · If stored assembled or partially assembled, remember to protect the fan head from dust. ADJUSTMENT INSTRUCTIONS Tilt Adjustment To change the tilting angle of the fan head, move the fan head to the desired angle. SERVICE INSTRUCTIONS 1. Do NOT attempt to repair or adjust any electrical or mechanical functions on this unit. If you have any questions regarding this unit's operation or believe any repair is necessary, please write to our consumer service department. [. . . ] Carefully pack the item in its original carton or other suitable box to avoid damage in shipping. Before packing your unit for return; be sure to enclose: a) your name, full address with zip code and telephone number, b) a dated sales receipt or PROOF OF PURCHASE, c) your $5. 00 check for return packaging, and d) The model number of the unit and the problem you are having. (Enclose in an envelope and tape directly to the unit before the box is sealed. ) 3. Holmes recommends you insure the package (as damage in shipment is not covered by your warranty). [. . . ]