User manual HOLMES HAOF720

[. . . ] 8) DO NOT operate any appliance with a damaged cord or plug, if motor fan fails to rotate, after the appliance malfunctions, or if it has been dropped or damaged in any manner. Return appliance to manufacturer for examination, electrical or mechanical adjustment, or repair. 9) DO NOT operate in the presence of explosive and/or flammable fumes. 10) Use appliance only for intended household use as described in this manual. [. . . ] Make sure that the blade is pushed onto the motor shaft as far as possible before putting on the front grill. FOR HAOF1220, 1620 Align "D" shaped shaft with the "D" shaped hole in the center of the blade. Slide the fan blade, with the hollowed interior of the blade facing towards the rear of the grill firmly onto the motor shaft, until motor shaft protrudes from the front of the fan blade. Secure the fan blade onto the motor shaft by firmly tightening the fan blade nut. NOTE: TURN THE FAN BLADE NUT COUNTER-CLOCKWISE Step 5: Center the front grill by aligning the Holmes logo on the grill hub so it is horizontal and parallel with the floor, making sure that the grill clips are in the open position. Closing the clips will attach the front grill to the rear grill. OPERATING INSTRUCTIONS Step 1: Set the fan base on a dry, level surface. Step 2: Please make sure the Speed Control Knob is in the "O" Off position. Plug the cord into any standard 120-volt A/C outlet. Step 3: The SPEED is adjusted by moving the knob left or right to the desired setting. Step 4: The OSCILLATION control knob is located on the top of the fan motor housing. To start oscillation, push control knob down. To stop oscillation, pull control knob up. ADJUSTMENT INSTRUCTIONS Tilt Adjustment To change the tilting angle of the fan head, move the fan head to the desired angle. CLEANING/MAINTENANCE Follow these instructions to correctly and safely care for your Holmes table fan. Please remember: · Always unplug the fan before cleaning or disassembling. · Do not allow water to drip on or into the fan motor housing. · Do not use any of the following as a cleaner: gasoline, thinner, or benzine (See instructions for fan head assembly) Step 1: To access the fan blade, remove the front grill and the fan blade nut. Step 2: Clean the fan blade, both front and rear grills with a soft cloth moistened with a mild soap solution. Step 3: Replace blade, tighten the fan blade nut, and securely fasten the front grill. Fan Head and Base Cleaning Using a soft, moist cloth, with or without a mild soap solution, carefully clean the fan base and head. Please use caution around the motor housing area. Do not allow the motor or other electrical components to be exposed to water. FAN STORAGE Your fan can be stored in the off-season either partially disassembled or assembled. It is important to keep it in a safe, dry location. · If stored disassembled, we recommend using the original (or appropriately sized) box. [. . . ] Carefully pack the item in its original carton or other suitable box to avoid damage in shipping. Before packing your unit for return; be sure to enclose: a) your name, full address with zip code and telephone number, b) a dated sales receipt or PROOF OF PURCHASE, c) your $5. 00 check for return packaging, and d) The model number of the unit and the problem you are having. (Enclose in an envelope and tape directly to the unit before the box is sealed. ) 3. Holmes recommends you insure the package (as damage in shipment is not covered by your warranty). [. . . ]