User manual HOLMES HASF1522

[. . . ] · To disconnect, grip plug and pull from wall outlet. · Always use on a dry, level surface. · Do not operate without fan grills properly in place. · This product is intended for household use ONLY and not for commercial or industrial applications. PLEASE READ AND SAVE THESE INSTRUCTIONS WARNING: To reduce the risk of fire or electrical shock, DO NOT USE THIS FAN with any SOLID STATE Fan Speed Control Device THIS PRODUCT IS EQUIPPED WITH A POLARIZED A. C. [. . . ] Now, slowly turn the pole with the threaded joint clockwise to lock it securely in place (see figure #2). (fig 2) CUTAWAY/ GROOVES THREADED JOINT (male end) HOLLOW END (female end) K. BASE NUT R S T U V Final Assembly: Insert the fan head neck joint (see figure #3) into the hollow end of the top pole and slowly turn the neck joint to lock in place. Be careful to align the cutaway/grooves on the neck joint with the two protruding raised pieces inside the hollow end of the pole. Lastly, insert the tilt adjustment knob into the neck joint and tighten until it is securely in place. Page2 OPERATING INSTRUCTIONS: Step 1. Plug cord into any standard 120 volt AC outlet. Please make sure the Speed Control Knob is in the Off position. This knob is located on the top of the Fan Motor Housing. The speed is adjusted by turning the control knob to the desired setting, Off-High-Med-Low. The Oscillation Control Bar is located on the top of the Fan Motor Housing. Special Note: This fan can be used in a "straight-up"(Total-Flex) position, as a whole room air circulator (See Adjustment Instructions). Fan Head, Base, and Pole Cleaning: Using a soft, moist cloth, with or without a mild, soap solution, carefully clean the fan base, pole, and head. Please use caution around the motor housing area. Do not allow the motor or other electrical components to be exposed to water. FAN STORAGE: Your fan can be stored in the off-season either partially disassembled or assembled. It is important to keep it in a safe, dry location. · If stored disassembled, we recommend using the original (or appropriately sized) box. · If stored assembled or partially assembled, remember to protect the fan head from dust. The exclusive Holmes Products FanBonnet is available to protect your fan. (See attached mail order form for special offer or call 1-800-5-HOLMES) ADJUSTMENT INSTRUCTIONS: Height Adjustment: This fan is equipped with two poles which allow you to adjust the height of the fan for three height settings. · Small Pole Only 30" · Larger Pole Only 35" · Both Poles for 50" FAN SERVICE INSTRUCTIONS: 1. Do NOT attempt to repair or adjust any electrical or mechanical functions on this unit. If you have any questions regarding this unit's operation or believe any repair is necessary, please call 1-800-5 HOLMES to speak with a Customer Service Representative. If you need to exchange the unit, please return it in its original carton, with a sales receipt, to the store where you purchased it. If you are returning the unit more than 30 days after the date of purchase, please see the enclosed warranty. [. . . ] Within the first 30 days from date of purchase, the store from which you purchased your Holmes product should replace this product if it is defective in material or workmanship (provided the store has instock replacement. ) 2. Within the first sixty months from date of purchase, subject to the conditions in paragraph H, Holmes will repair or replace the product if it is defective in material or workmanship providing it is returned to Holmes, freight prepaid, with PROOF OF PURCHASE date, together with $10. 00 for return shipping and handling charges. If you have any problem with this product, please write our Customer Service Dept. , or call, 1-800-5-HOLMES. IMPORTANT RETURN INSTRUCTIONS Your warranty depends on your following these instructions if you are returning the unit more than 30 days after the date of purchase: 1. [. . . ]