User manual HOLMES HASF1650

[. . . ] Further, the warranty does not cover: Acts of God, such as fire, flood, hurricanes and tornadoes. What are the limits on JCS's Liability?JCS shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or statutory warranty or condition. Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty. [. . . ] Outdoor applications provide a cool, refreshing breeze on hot stagnant days as well as warding off annoying insects or barbecue smoke. Plug cord into any standard 120 volt AC outlet. Please make sure the Selector (Speed) Control is in the OFF position. Selector (Speed) Control is located at the rear of the Fan Motor Housing. The SPEED is adjusted by turning the control knob to the desired setting, OFF-III-II-I. The Oscillation Control Knob is located on the top of the Fan Motor Housing. To start Oscillation, push control knob down. To Stop Oscillation, pull control knob up. B C D E F G Figure 2 H CLEANING/MAINTENANCE INSTRUCTIONS Follow these instructions to correctly and safely care for your fan. Please remember: · Always unplug the fan before cleaning or disassembling. · Do not allow water to drip on or into the fan motor housing. · Do not use any of the following as a cleaner: gasoline, thinner, benzene. To access the fan blade, remove the front grill and securing screw. Clean the fan blade, front and rear grills with a soft, moist cloth. Replace blade, tighten securing screw and securely fasten the front grill. Fan Head, Base and Pole Cleaning Using a soft, moist cloth, with or without a mild soap solution, carefully clean the fan base, pole and head. Please use caution around the motor housing area. Do not allow the motor or other electrical components to be exposed to water. PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS ASSEMBLY INSTRUCTIONS NOTE: MAKE SURE YOU REMOVE ALL CONTENTS OF THE PACKAGE. PLEASE CHECK PACKAGING MATERIALS FOR PARTS THAT COULD BE REQUIRED TO ASSEMBLE YOUR FAN. Base/Pole Assembly You will need the base, Round Weight, pole assembly, pole ring, washer and L-shaped locking lever (See Figure 1-2). Slide the bottom end of the outer pole through the pole ring. Turn the base upside down and place the weighted insert and washer into the base cover. Secure the base and round weight to the bottom of the outer pole using the L-shaped locking lever and washer. [. . . ] fan head assembly into this extension pole, inserting the Slide the fan blade, with the hollowed interior of the neck of the fan into the pole opening. Turn the fan blade facing toward the rear grill, firmly onto the head's neck until the head is securely locked into place. The top of the motor shaft should lie Finally, add the tilt adjustment knob to the hole of the even with the center of the fan blade. Tighten when fan head is in your Line up the hole on the shaft of the fan blade with desired position. [. . . ]