User manual HOLMES HFH5606

[. . . ] If the product is no longer available, replacement may be made with a similar product of equal or greater value. Do NOT attempt to repair or adjust any electrical or mechanical functions on this product. This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable. JCS dealers, service centers, or retail stores selling JCS products do not have the right to alter, modify or any way change the terms and conditions of this warranty. [. . . ] This heater is not intended for use in bathrooms, laundry areas and similar indoor location. NEVER locate heater where it may fall into a bathtub or other water container. Extreme caution is necessary when any heater is used by, or near children or invalids, and whenever the heater is left operating and unattended. Always unplug the heater when not in use. When unplugging, be sure to pull by the plug and not the cord. DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater. DO NOT operate heater with a damaged cord or plug, or after the heater malfunctions, has been dropped or damaged in any manner. DO NOT use it in areas where gasoline, paint, or flammable liquids are used or stored. Use appliance only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold by the manufacturer may cause hazards. To prevent a possible fire, DO NOT block air intakes or exhaust in any manner. DO NOT use on soft surfaces, like a bed, where openings may become blocked. To disconnect heater, turn controls to OFF, then remove plug from outlet. Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord, the cord shall be No. 14 AWG minimum size and rated not less than 1875 watts. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. The inside of the unit contains no user serviceable parts. Please do not manually turn the unit, it is designed to turn only by motorized oscillation. Your heater is equipped with a technologically advanced 1Touch® electronic thermostat. You can set the heater to run continuously in manual mode or set the 1Touch® thermostat to your desired temperature setting. [. . . ] After the 10 minutes, plug the unit in again and operate normally. If you find an obstruction turn the heater OFF, and unplug the unit. Carefully remove the obstruction and follow the reset instructions. ⷠThe temperature may be set too low. [. . . ]