User manual HOLMES HM2408UC05EFM1

[. . . ] HM2408UC05EFM1. qxd 5/26/05 08:17 Page 1 TROUBLESHOOTING F R E Q U E N T LY A S K E D Q U E S T I O N S TROUBLE Unit does not turn on Mist output minimal to none Filter turns brown PROBABLE CAUSE Not plugged in Filter has not absorbed water The filter has absorbed minerals SOLUTION Plug in unit Wait 15 minutes for filter to absorb water Replace your filter (HWF62) by calling 1-800-5-HOLMES, or visit www. holmesproducts. com REPLACEMENT ACCESSORIES REPLACEMENT ACCESSORIES To order the replacement accessories you can do any of the following: · Fill out the accessories card found with the product · Visit your local retailer · Go to www. holmesproducts. com · Call consumer service at 1-800-5-HOLMES SERVICE INSTRUCTIONS 1. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. If you need to exchange the unit, please return it in its original carton, with a sales receipt, to the store where you purchased it. If you are returning the unit more than 30 days after the date of purchase, please see the enclosed Warranty. [. . . ] This air is then passed through a moisture­laden wick filter, which retains the minerals and deposits in the water. The resulting moist air is directed back into the room from the top air grill. NOTE: This humidification system provides a cool, invisible moisture output. NOTE: A humidity level below 20% can be unhealthy and uncomfortable. The recommended humidity level is between 40%-50%. ® REPLACING THE FILTERS Through normal use, waterborne minerals and sediment become trapped in the wick filter. The harder your water, the greater the amount of minerals in the water, and the more often you will need to change your filter. You will be able to monitor the life of the filter in your humidifier by checking the FilterCheck® Indicator. After 60 minutes of use, FilterCheck® Indicator will move and indicate your filter condition. A brand new filter will register in the section reading GOOD filter. After frequent Figure 2 use of your humidifier, the FilterCheck® Indicator will let you know when the filters need to be changed, see Figure 2. When the needle is in the CHANGE section, this means the proper amount of moisture is not getting into your air due to the excessive minerals and sediment that have become trapped on your filters. At this point, you should replace your filter. It is important to change your filter as indicated to obtain stated performance level. To replace the filter, follow the steps below: 1. Turn the unit off and disconnect from the electrical outlet. Remove the tank and main housing to access the base tray. Follow the weekly cleaning instructions. It will take about 30 minutes for the humidifier to reach maximum output. You can purchase replacement filters (model HWF62) at a local retailer, by calling 1-800-5-HOLMES, filling out the accessory card, or by visiting www. holmesproducts. com. It is recommended that a replacement filter is purchased for uninterrupted use. DAILY MAINTENANCE 1. Be sure the unit is OFF and is disconnected from the electrical outlet. Remove the housing and the tank from the humidifier and place in sink or tub. [. . . ] IL NE FAUT PAS ESSAYER N'ANNULER L'EFFET SÉCURITAIRE DE CETTE FICHE POLARISÉE. CONSIGNES PRÉ-UTILISATION 1. Assurez-vous que l'humidificateur est éteint (OFF) et débranché. Choisissez un emplacement pour votre humidificateur : une surface plane à environ 4 po du mur. Réservoir de l'humidificateur B. [. . . ]