User manual HOMELITE HG5022P

[. . . ] When properly cared for, it will give you years of rugged, trouble-free performance. You WILL be KILLED or SERIOUSLY HURT if you do not follow the instructions in this operator's Thank you for your purchase. A - move choke lever left to run (pousser gauche le levier d'étranglement pour la marche, desplace izquierda la palanca del anegador para poner en marcha) B - move choke lever right to start (tirer droite le levier d'étranglement pour démarrer, desplace derecha de la palanca del anegador para arrancar) A - Air filter cover (couvercle du filtre à air, tapa del filtro de aire) B - Latches (loquets, pestillos) C - Filter element (élément du filtre, elemento de filtro) D - Air filter unit (unité de filtre à air, unidad del filtro de aire) This product has many features for making its use more pleasant and enjoyable. Safety, performance, and dependability have been given top priority in the design of this product, making it easy to maintain and operate. [. . . ] To avoid back injury, lift with your legs and not your back. Do not use this product if any parts on the Loose Parts List are already assembled to your product when you unpack it. Parts on this list are not assembled to the product by the manufacturer and require customer installation. Use of a product that may have been improperly assembled could result in serious personal injury. Inspect the unit carefully to make sure no damage occurred during shipping. Do not discard the packing material until you have carefully inspected and satisfactorily operated the product. If any parts are damaged or missing, please call 1-800-242-4672 for assistance. Locate the following items: 2 support feet, 2 nuts (1/4-20), 2 flat washers, 2 lock washers, 2 bolts (1/4-20 x 1-1/2 in. ) Position the generator and the support foot so the holes in the support foot align with the holes in the generator frame. Wheels are provided to assist in moving the generator to the desired location and should be installed on the side opposite the handle. Locate the following items: 2 axles, 2 hitch pins, 2 washers, 2 wheels Raise the end of the generator where the handle is located high enough to gain access to the frame bottom; securely position props underneath to support. Slide the axle through the hole in the center of the wheel. Slide a washer onto the axle, then slide the axle into the wheel mounting hole as shown. NOTE: The hitch pin should be pushed into the axle until the center of the pin rests on top of the axle. Do not attempt to lift the unit by the handle assembly. If it is necessary to lift the generator, always grasp by the frame. Use proper lifting techniques to avoid back injury. Make sure the handle is securely locked in place before attempting to move the generator. To collapse the handle for storage, pull and hold the release pin while pushing the handle down. If you can smell the generator exhaust, you are breathing CO. But even if you cannot smell the exhaust, you could be breathing CO. Never use a generator inside homes, garages, crawlspaces, or other partly enclosed areas. [. . . ] 3hp or greater) The repair or replacement of any part or parts under this Limited Warranty shall not extend the term of the engine warranty beyond the original term as set forth above. LIMITATIONS AND EXCLUSIONS: This Limited Warranty shall not apply to: Bent or broken crankshaft or resultant damage caused by vibration related to a bent or broken crankshaft. also , damage caused by loose engine mounting bolts or improper or imbalanced accessories or blades mounted to the crankshaft. Repairs required because of prolonged storage including damage caused by old or contaminated fuel in the fuel tank, fuel lines or carburetor, sticky valves or corrosion and rust of engine parts. [. . . ]