User manual HOMELITE HG5700

[. . . ] Your generator has been engineered and manufactured to our high standard for dependability, ease of operation, and operator safety. When properly cared for, it will give you years of rugged, trouble-free performance. You WILL be KILLED or SERIOUSLY HURT if you do not follow the instructions in this operator's Thank you for your purchase. This product has many features for making its use more pleasant and enjoyable. [. . . ] Failure to comply could result in possible serious personal injury. NOTE: Do not put fuel or lubricant in the generator before installing the feet, frame support, and wheels. Locate the following items: 2 rubber feet 2 lock nuts (1/4-20) 2 washers (1/4 in. ) Insert bolt through foot, then through frame support as shown. NOTE: Be careful not to overtighten so that foot material collapses. Install the frame support on the bottom of the generator frame on the same side as the handle. Locate the following items: Frame support 2 flange nuts (5/16-18) 2 washers (5/16 in. ) Raise the end of the generator where the recoil starter is located high enough to gain access to the frame bottom; securely position props underneath to support. align the holes on the frame support with the holes on the generator frame. Slide a washer on the bolt, then insert the bolt through the hole in the generator frame so it extends down through the frame support. install flange nut and tighten securely. Wheels are provided to assist in moving the generator to the desired location and should be installed on the side opposite the handle. 38 ID) 2 wheels 2 lock nuts (3/8-16) Raise the end of the generator opposite the handle high enough to gain access to the frame bottom; securely position props underneath to support. Insert a wheel spacer into the center of the wheel. Place a washer on the bolt, then slide bolt through the wheel. Thread another washer on the bolt, then slide the bolt through the U-bracket frame on generator. Repeat the process on the other side to install second wheel. Locate the following items: Handle lock pin Lanyard Attach the lanyard to the handle lock pin and the handle as shown in figure 4. Do not attempt to lift the unit by the handle assembly. If it is necessary to lift the generator, always grasp by the frame. Use proper lifting techniques to avoid back injury. Only use OUTSIDE and far away from windows, doors, and vents. [. . . ] During the period of warranty any authorized Yamaha SORE engine repair station will, free of charge, repair or replace, at Yamaha's option, any part adjudged defective by Yamaha due to faulty workmanship or material from the factory. parts used in warranty repairs will be warrantied for the balance of the product's warranty period. All parts replaced under warranty become property of Yamaha Motor Corporation USA. emissions warranty -- emissions-related components will be warrantied for 2 years regardless of commercial or noncommercial use. [. . . ]