User manual HOMELITE HL252300

[. . . ] Your pressure washer has been engineered and manufactured to our high standard for dependability, ease of operation, and operator safety. When properly cared for, it will give you years of rugged, trouble-free performance. WARNING: To reduce the risk of injury, the user must read and understand the operator's manual before using Thank you for your purchase. This product has many features for making its use more pleasant and enjoyable. [. . . ] replace fuel cap and tighten until the cap "clicks". Clean up any spills before starting the engine. The pressure washer pump has been filled with sufficient lubricant at the factory. You do not need to check or add lubricant to the pump. Overfilling the crankcase may cause excessive smoke and engine damage. Do not run the pump without the water supply connected and turned on. Turn on the garden hose then pull the trigger to relieve air pressure; hold the trigger until a steady stream of water appears. NOTE: If the engine is warm, leave the choke lever in the ON (COLD START) position. Allow the engine to run for 5 seconds, and then push the choke to the RUN position. NOTE: Fuel system damage or performance problems resulting from the use of an oxygenated fuel containing more than the percentages of oxygenates stated below are not covered under warranty. Put the engine switch in the ON position. Pull the recoil starter grip until the engine runs (a maximum of 6 times). NOTE: Do not allow the grip to snap back after starting; return it gently to its original place. Allow the engine to run for 5 seconds, then push the choke lever to the RUN position. to stop the engine: Put the engine switch in the OFF position. NEVER change nozzles without locking the lock out on the trigger handle and NEVER point the wand at your face or at others. The quick-connect feature contains small springs that could eject the nozzle with some force. To connect a nozzle to the trigger handle: Turn off the pressure washer and shut off the water supply. Engage the lock out on the trigger handle by pushing up on the lock out until it clicks into the slot. Push the nozzle into place in the quick-connect collar until it clicks into place and is secured properly. To disconnect a nozzle from the trigger handle once the cleaning job is complete: Turn off the pressure washer and shut off the water supply. Engage the lock out on the trigger handle by pushing up on the lock out until it clicks into the slot. [. . . ] As the small off-road engine purchaser/owner, you should, however, be aware that CHONGQING RATO POWER CO. May deny any and/or all warranty coverage or responsibility if your engine, or a part/component thereof, has failed due to abuse, neglect, improper maintenance or unapproved modifications, or the use of counterfeit and/or "grey market" parts not made, supplied or approved by CHONGQING RATO POWER CO. You are responsible for presenting your engine to a CHONGQING RATO POWER CO. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days. [. . . ]