User manual HONEYWELL 17000

[. . . ] Do not use air cleaner where combustible gases or vapors are present. Do not expose the air cleaner to rain, or use near water, in a bathroom, laundry area or other damp location. To disconnect the air cleaner, first turn the air cleaner OFF and remove plug from the outlet. The air cleaner must be used in its upright position. [. . . ] The filter monitors are intended as guidelines only, as individual use may vary. Check Pre-filter life used by quickly pressing the pre-filter monitor button: 1 Flash NEW 2/3 life remains 2 Flashes 3 Flashes Replace 900 Hours* 1/3 life left remains Check HEPA filter life used by quickly pressing the HEPA filter monitor button: 1 Flash NEW 3/4 life remains 2 Flashes 3 Flashes 4 Flashes Replace 6, 000 Hours* 1/2 life left remains 1/4 life left remains *If operated an average of 12 hours a day on medium speed, the filter monitor light will indicate replacement in about 3 months for the pre-filter, and about 1 year and 9 months for the HEPA filter. NOTE: If operated on a higher speed for a greater number of hours each day, the filter light monitors will indicate replacement sooner than if operated on a lower speed for fewer hours each day. RESET Filter Monitor After Filter Replacement. When the filter monitor light remains on, it is time to replace the filter. Once the filter has been replaced, you must reset the filter monitor. With the unit powered on, press the filter monitor button down for a 5 second delay. The light will turn off. Replacement Filter s. . . Use only genuine Honeywell replacement filters designed for these units. Select the proper replacement filter for your Honeywell HEPA Air Cleaner from the chart below: Model No. 17000 17200 17250 17400 17440 17450 HEPA Filter Part Number 20500 21500 28720 22500 22500 28725 Carbon Pre-filter Part Number 32002, 38002 32000, 38002 32002, 38002 33002, 38002 33002, 38002 33002, 38002 CPZTM Kit (includes 2 prefilters) NA NA 21200 NA NA 22200 Replacement filters may be purchased from the retail store or ordered from the dealer where you purchased the product. If you cannot locate one in your area please call our Consumer Relations Dept. at (800) 332-1110 for assistance. When to Replace Filters RESET THE FILTER MONITOR ONCE EACH FILTER HAS BEEN REPLACED. See "Filter Check/Reset Monitors" section for further details. For model 17250 and 17450 series, after replacing the CPZTM filter, use the enclosed CPZTM filter reminder label to indicate the next time the filter is to be replaced (approximately every six months). CAUTION: Do not attempt to wash either the activated carbon pre-filter, the HEPA filter or the CPZTM filter. They are not washable and washing will damage the filters. With proper maintenance, your Honeywell air cleaner is designed to provide years of high efficiency air cleaning. Your Honeywell air cleaner contains two filters: one activated carbon pre-filter and one primary HEPA filter. Models 17250 and 17450 contains three filters: one activated carbon pre-filter, one primary HEPA filter, and a CPZTM odor and gas adsorbing filter. The activated carbon pre-filter captures lint and other large particles and helps protect the HEPA filter. It also helps reduce common household odors. The pre-filter should be replaced at least every 3 months. You may need to replace the pre-filter more often if the unit is used in a smoking environment or if unpleasant odors persist. We DO NOT recommend operating the air cleaner without the activated carbon pre-filter or without following the filter replacement guidelines. [. . . ] Please include your name, address and daytime phone number. Mark carton "Attention Repair Department" Ship to: Honeywell Consumer Products 4755 Southpoint Drive Southpoint Distribution Center Memphis, TN 38118 U. S. A. Honeywell Consumer Products Canada 510 Bronte St. South Milton, Ontario Canada L9T 2X6 If you experience a problem with your air cleaner, please see owner's guide for instructions. [. . . ]