User manual HONEYWELL DPTM50-5000

[. . . ] 3-WIRE DIFFERENTIAL PRESSURE TRANSMITTERS WITH CURRENT AND VOLTAGE OUTPUT SPECIFICATION DATA & MOUNTING INSTRUCTIONS DPTM50-5000 FEATURES · · · · · · · · · Monitoring gaseous, non-aggressive media Piezo-resistive pressure transducer Up to 40 kPa (60 kPa) overload capacity Rugged design; protection class IP54 Easy installation and wiring connection Measurement range adjustable by jumper Response time adjustable by jumper Output signal adjustable by jumper Re-zeroing possible by pushbutton NOTE: These sensors are not suitable for use in installations under periodic inspection by the U. S. Food and Drug Administration. SPECIFICATION Supply voltage Output signal Pressure medium Working temperature Linearity and hysteresis error Temperature error at 0. . . 50°C Storage temperature Humidity Repetition accuracy Response time Process connection Electrical connection Housing material Cable entry Protection class EMV Weight 18. . . 30 Vac/dc, 50/60 Hz 0. . . 10 Vdc, 4. . . 20 mA Air, non-aggressive gases 0. . . 50 °C ± 1. 0% of FS See section "Models" -10. . . +70 °C 0. . . 95% rh, non-condensing ± 0. 2% of FS 1 s (switchable to 100 ms) 6 mm hose pipe Screw terminal block for wire up to 1. 5 mm² ABS and POM M20x1. 5 (polyamide) IP54 as per EN60529 EN60770, EN61326 approx. [. . . ] The pressure to be measured is applied to and thus deflects a thin membrane made of monosilicon. The membrane's semiconductor resistors (arranged to simultaneously compensate for the temperature response) detect this deflection and generate an electrical output signal. The output signal is converted into the 0. . . 10 V or 4. . . 20 mA analog signal which changes (within the specified error limits) in proportion to the applied pressure. NOTE: The devices are factory pre-set to pressure range 1. This can be changed (except for +/- models) to pressure range 2 by removing the corresponding jumper (see Fig. NOTE: The devices are factory pre-set to a response time of 1 second. This can be changed to 100 ms by removing the corresponding jumper (see Fig. NOTE: The devices are factory pre-set to an output signal of 0. . . 10 V. This can be changed to 0. . . 20 mA by removing the corresponding jumper (see Fig. Mounting WIRING PRESSURE RANGE jumper inserted = pressure range 1 jumper removed = pressure range 2 RESPONSE TIME jumper inserted = 1 sec jumper removed = 100 msec ACCESSORIES DPSK: Included in delivery. [. . . ] Wiring details Manufactured for and on behalf of the Environmental and Combustion Controls Division of Honeywell Technologies Sàrl, Ecublens, Route du Bois 37, Switzerland by its Authorized Representative: Fema Controls Honeywell GmbH P. O. Box 1254 71099 Schönaich Germany phone: (49) 7031-637-02 fax: (49) 7031-637-850 http://www. honeywell. de/fema Subject to change without notice. [. . . ]