User manual HONEYWELL HA30

[. . . ] For security reasons automatic control of awnings on the basis of the wind speed is only allowed with the wind sensor HWS 40! 2 Mounting Mounting Danger to life through electric shock!Live electrical contacts lie open while the module is being cabled. Touching a live contact causes critical injuries. All work may only be carried out by authorized specialized personnel. [. . . ] The teach-in mode remains active for a maximum of 4 minutes. Afterwards the shutter module changes back to normal mode. Therefore familiarize yourself with the following steps beforehand. 1. Activating the teach-in mode at the shutter module Use the "Up" button to open the shutter completely. Within 10 seconds press the "Down" button briefly exactly 5 times. Ensure that the motor moves after each pressing action. The shutter module does not recognize if the pressing action is too fast or too brief. As confirmation the shutter travels downwards for 2 seconds. The teach-in mode at the shutter module is activated. 8 Teach-in 2. Activating the teach-in mode at the Hometronic Manager The yellow LED at the Hometronic Manager lights up. Hometronic WE 29. 10. 1999 11:15 No Lifestyle active LIVING 20. 0 C MENU SET DATE/TIME ACTIVATE LIFESTYLE LIVING 20. 0 C MENU SET DATE/TIME ACTIVATE LIFESTYLE LIVING 20. 0 C LIFESTYLES TIME PROGRAMS DISPLAY SETTINGS HEATING SHUTTERS DEVICES/LIGHT SENSOR 9 The display shows the standard display, for example: Press the Dial button at the Hometronic Manager. order to move the cursor to the highest line. Turn the Dial button to the right in Press the Dial button. The following text is displayed: Select "Settings" and press the Dial button twice. The following text is displayed: Teach-in Turn the Dial button to the left in order to select the "Shutters" submenu. HEATING SHUTTERS DEVICES/LIGHT SENSOR MODULE-1 MODULE-2 MODULE-3 MODULE-4 MODULE-1 MODULE-2 MODULE-3 MODULE-4 * Press the Dial button. The following text is displayed: Select the module to be installed, in this case Module 2. Press the Dial button in order to MODULE-1 MODULE-2 activate the teach-in mode. A sis displayed next to the selected MODULE-3 MODULE-4 module (in this case Module 2). The Hometronic Manager is ready for data transfer. The teach-in mode is active. The teach-in was successful, if the shutter travels completely upwards. 10 Teach-in 3. Determining the end position If it is not possible to travel to end positions or a button action is interrupted, the teach-in has to be repeated. Keep the "Down" pushbutton/switch pressed until the shutter reaches the lower end position and the drive stops. Keep the "Up" pushbutton/switch pressed until the shutter reaches the upper end position and the drive stops. The teach-in mode is terminated. Setting the 50% position (optional) The shutter module can determine half the opening width of a shutter exactly. The Hometronic Manager can thus open and close the shutter with greater precision. [. . . ] Live electrical contacts are exposed when the contact covers are opened. Touching a live contact causes critical injuries. De-energize the corresponding circuit. Ensure that the contact covers are closed. Remove the defective fuse (see figure). Insert a new fuse (ceramic tube, 250 V, 5 x 20 mm, 2 A, fast). Replace the housing cover and latch it in. 17 Information for the fitter Information for the fitter After mounting and starting up has been completed, the Hometronic System can be handed over to the customer. [. . . ]