User manual HONEYWELL HS10S

[. . . ] HS10S Combination water supply unit Product specification sheet Application HS10S combination water supply units integrate a check valve with test point, reverse rinsing fine filter, pressure reducing valve and shutoff valve in one appliance. They ensure a continuous supply of filtered water. [. . . ] Technical Data Installation position Horizontal, with filter bowl downwards Operating temperatureMax. 70 °C with red-bronze filter bowl Operating pressure Min. 1. 5 bar 1/ " - 2" Connection size 2 www. honeywell. com 3 HS10S Combination water supply unit Method of Operation The combination water supply unit combines check valve, reverse rinsing fine filter, pressure reducing valve and shutoff valve in one appliance. Water flows first through the check valve. This causes the valve stem to push against the spring force and open the valve. The downstream reverse rinsing fine filter holds back any dirt particles in the water. These particles are then completely flushed out by reverse rinsing. Filters with Double Spin Technology have turbine blades which circulate the water and thereby set the rotor on the upper filter into a rotational motion. The internal impeller rinses off particles that have adhered to the upper filter at the intersecting points with the rotor. The integral pressure reducing valve functions on a balanced force principle whereby the force exerted by a diaphragm is balanced against the force of an adjustment spring. The inlet pressure has no influence on opening or closing of the valve. Inlet pressure fluctuation does not therefore affect the outlet pressure. [. . . ] 0901515 0901517 0901518 D06FA-1/2 D06FA-1A D06FA-11/2 0901444 0901445 0901446 0901447 0901448 2166200 2110200 2164400 2164500 2164600 2164700 2421100 M38K-A10 M38K-A16 M38K-A25 AF11S-1/2A AF11S-1A AF11S-11/2A AF11DS-1/2A AF11DS-1A 6 2 4 1 Spring bonnet completet (with setting scale) Valve insert complete (without filter) Seal ring set (Pack of 10) 2 + 3/4" 1" + 11/4" 11/2" + 2" 2" 1/ 2" 1/ 3 + 3/4" 3 14 4 Check valve cartridge 1" 11/4" 11/2" 2" 1/ 3/ 2" 4" 5 1" 11/4" 11/2" 2" 5 Test valve 1/ 2" - 2" 7 8 6 7 Pressure gauge (0-10 bar) Pressure gauge (0-16 bar) Pressure gauge (0-25 bar) 1/ " - 3/ " Filter insert complete* 2 4 1" - 11/4" Filter mesh 100 µm 11/2" - 2" Filter insert complete* for 1/2" - 3/4" filters with Double Spin 1" - 11/4" Technology, Filter mesh 100 µm Clear filter bowl 1/ 1/ 1/ 1 2" - 1 /4" 11/2" - 2" 1 2" - 1 /4" 1/ " - 2" 12 1 2" - 1 /4" 11/2" - 2" 8 without Double Spin Technology with Double Spin Technology 11 9 KF11S-1A KF11S-11/2A FT09RS-1A FT09RS-11/2A 0900747 0900748 AA76-1/2A KH11S-1A 2192900 2193100 2193200 2193300 2193400 2193500 ZR10K-3/4 ZR10K-1 ZR10K-11/2 10 Red-bronze filter bowl 11 O-ring set (Pack of 10) 9 12 Drain connector 13 Ball valve complete 14 Shutoff valve (not included in HS10S-ZS) 1/ " 2 1/ " 2 1/ 3/ 2" 4" - 2" - 2" 13 1" 11/4" 11/2" 2" 1/ " - 3/ " 15 Double ring wrench 2 4 for removing filter bowl 1" - 11/4" and spring bonnet (no fig. ) 11/2" - 2" 12 * The filter guide (either with double spin or without double spin feature) is included in the packaging of the replacement filter inserts (AF11DS and AF11S) only for the sizes 1/2" up to 11/4! Automation and Control Solutions Honeywell GmbH Hardhofweg D-74821 Mosbach Phone: (49) 6261 810 Fax: (49) 6261 81309 http://europe. hbc. honeywell. com www. honeywell. com Manufactured for and on behalf of the Environmental and Combustion Controls Division of Honeywell Technologies Sàrl, Rolle, Z. A. La Pièce 16, Switzerland by its Authorised Representative Honeywell GmbH EN0H-1101GE23 R0109 Subject to change without notice © 2009 Honeywell GmbH [. . . ]