User manual HONEYWELL S245S

[. . . ] Install the safety valve in such a way that during venting no harm can occur to persons or objects adjacent to the unit. [. . . ] If the installation is taken out of service for a long period, then the unit should be returned to the venting position. This is achieved by turning the adjusting knob four turns anticlockwise until it is loose. Materials: Seal washer: Fluorine caoutchouc Bellow: Silicon caoutchouc Discharge hood: Polyamide Housing: Brass Applications: Fixed vessels for granular or powdered materials which are filled or emptied by means of compressed air. Tanker vehicles for fluids, granular or powdered materials which are filled and emptied by means of compressed air. Ensure dirt does not build up around the discharge area of the safety valve. The intervals for function checks of the safety valves must be fixed by the operator of the installation under consideration of the local requirements for pressure tanks (at least once a year according to the recommendation of the manufacturer). The facility operator should ensure that the function tests are carried out regularly by an authorized person. Adjustment of pressure setting and repair operations may only be carried out by the manufacturer. [. . . ] Manufactured for and on behalf of the Environment and Combustion Controls Division of Honeywell Technologies Sàrl, Ecublens, Route du Bois 37, Switzerland by its Authorised Representative Honeywell GmbH MU1H-1310GE23 R1005 Subject to change without notice © 2005 Honeywell GmbH [. . . ]