User manual HONEYWELL T7200

[. . . ] Additionally, the T7270A2001 allows the room setpoint temperature to be adjusted. The T7270A2001/T7200 transmit the data to the W7070A2000 at 868. 3 MHz. 2 Additional Features of T7270A2001 The T7270A2001 ZAPP Wireless Wall Module has the following functions (in addition to those of the T7200): Adjustment wheel at which you can change the room temperature setpoint directly. The adjustment range amounts to ± 12 °C, starting from the basic value of 20 °C (in position 0). 1 Fig. [. . . ] Registered Trademark Copyright © 2007 Honeywell Inc. · All rights reserved EN1B-0397GE51 R1207A T7270A2001/2019 WIRELESS WALL MODULE Remove the housing cover of the T7270A2001 / T7200 (see Fig. 2). Installation Remove the batteries. Mark the drill holes according to the drilling template (see Fig. 4). R2 RED LED TEACH-IN BUTTON 4 86 99 R2 4 68 82 Fig. Battery polarity and "Teach-In" button Insert the supplied AA batteries with the correct battery polarity (see Fig. If the red LED of the T7270A2001 / T7200 flashes, this means that the batteries must be replaced (see section "Changing Batteries"). Place the T7270A2001/T7200 at the installation site, but do not install it yet. Allocate the corresponding temperature zone to the T7270A2001/T7200 see System Engineering (EN0B-0286GE51) for information on the "teach-in" procedure. Drill the holes. If appropriate, put the adjustment wheel back in, rotated by 180°, until it has the position shown. Turn the adjustment wheel to Position 0. Place the housing cover in position above and snap it down (see Fig. 5). 3 EN1B-0397GE51 R1207A T7270A2001/2019 WIRELESS WALL MODULE CHANGING BATTERIES Change the batteries if the red LED of the room temperature sensor flashes and the device is not in test mode. Remove the housing cover of the T7270A2001 / T7200 (see Fig. Dispose of the batteries according to the local statutory requirements and not together with the usual domestic refuse. TECHNICAL DATA Batteries Frequency 1. 5 V, type LR06, AA 868. 3 MHz (transmitter) WEEE DIRECTIVE 2002/96/EC At the end of the product life, dispose of the packaging and product in a corresponding recycling center. Do not dispose of the unit with the usual domestic refuse. Do not burn the product. Always replace both batteries together. Only use 1. 5 V batteries of the type LR06, AA. Insert the new batteries with the correct polarity into the battery compartment (see Fig. [. . . ] Place the housing cover on at the top and latch it in downwards (see Fig. 5). TROUBLESHOOTING Problem Teach-in failed Cause Batteries inserted incorrectly Radio connection failure Remedy Insert the batteries correctly. No measured data at W7070A2000 Batteries inserted incorrectly Radio connection failure Module not assigned or assigned incorrectly Eliminate interference sources (metal, wireless devices). Eliminate interference sources (metal, wireless devices). [. . . ]