User manual HONEYWELL T7350

[. . . ] · Convenient overrides allow temporary setpoint changes. 2 · Intelligent FanTM feature energizes fan continuously in the Occupied periods. Fan can also be configured for conventional heat or electric heat fan operation. · Remote sensor capability for temperature (including outdoor air and discharge air) and humidity sensors. · P+I+D control minimizes temperature fluctuations. [. . . ] NOTE: Before starting programming, use Table 2 to organize the program schedule. Setting Current Day/Time This can be done using the keypad. IMPORTANT Once you set the day/time once, you should not need to set it again. As a result, if you use a PDA to set the day based upon the calendar (MM/DD/ YYYY), the device will not allow the keypad to change the day. 5 63-2604 Table 2. Occupied and Not Occupied Period Start Times. Day Monday Tuesday Wednesday Thursday Friday Saturday Sunday NOTE: 12:00 PM is Noon, and 12:00 AM is Midnight. 6 63-2604 Occupied Period 1 Not Occupied Period 1 Occupied Period 2 Not Occupied Period 2 Temperature Occupied HEAT COOL Set Day/Time Day Time Override Temporary Temporary Occupied Not Occupied Not Occupied HEAT COOL Day Clear Occupied Not Occupied Start Time Schedule System Copy HEAT COOL Fan ON AUTO Run Schedule M19610BB Fig. When using the keypad to change the day/time: 1. Press Set Day until the current day is displayed. NOTE: Sun = Sunday, Mon = Monday, Tue = Tuesday, Wed = Wednesday, Thu = Thursday, Fri = Friday, Sat = Saturday. Press up or down until the current time is displayed. NOTE: Tapping Set Time changes the time in one hour increments. 4. 7 Press Run Schedule. 63-2604 Setting Schedule Times Use the keys in the "Schedule" area of the keypad for this procedure. NOTE: Anytime a start time is not required, press Clear Start Time. Press Day until desired day is displayed. Press Occupied or Not Occupied until the proper period is displayed. Press up or down until the desired start time is displayed. Repeat steps 2 through 5 until finished. NOTE: The thermostat must be in program mode to use the copy feature. If the thermostat is already in program mode, skip step 1. Press Day to select the day to be copied. Press Day until the day to receive the copy is displayed. NOTE: DONE displays for two seconds then the program display reappears. [. . . ] To use the default occupied override, press Temporary Occupied. NOTE: The default temperature setting is the Occupied setpoint. To select a temperature setting other than the default, press up or down until desired temperature offset displays (range is 0°F to 3°F). 11 Press Temporary Not Occupied. Press up or down to change the duration of the Not Occupied period (in days). 63-2604 NOTE: The default temperature setting is the Not Occupied setpoint. [. . . ]