User manual HONEYWELL T8195B

[. . . ] Heating/Cooling Thermostat and Subbase or Heating or Cooling Thermostat and Wallplate T8195A, B/Q682 OWNER'S MANUAL 69-0563-2 Welcome to the world of energy savings with your new Honeywell thermostat. The Honeywell name is your assurance of accurate control and reliable operation for years to come. This thermostat meets California Title 24 requirements--mandatory installation of automatic setback thermostats in new heating and cooling systems. During heating and cooling, this thermostat will automatically lower and raise the temperature in your home one or more times every 24 hours. [. . . ] 4) are for the program pins which can be inserted at ten-minute intervals. Three red and three blue program pins are included with your thermostat. The red pins start the high-temperature period; the blue pins start the low-temperature period. A heating program has been preprogrammed. for high temperature (comfort period); a blue pin is inserted at 10:00 p. m. for low temperature (energy saving period). Two additional sets of pins are located in the program 11 FLIP-UP COVER PROGRAM PINS THERMOSTAT COVER PROGRAM PIN SLOT PROGRAM INDEX WHEEL TIME INDICATOR ARROW PROGRAM PIN STORAGE M7348 Fig. 4--Program components. 69-0563--2 To change the pins or add a new energy savings period-- · To insert a pin, push it straight into the selected notch on the program dial until it's completely seated. · To remove a pin, press against program dial and pull the pin straight out. Do not attempt to change a pin if it is engaged with the program index wheel. · On heating-cooling systems, you must remove the program pins from the heating program to set new times for your cooling program. Write down your colors and time for reprogramming at the next heating season. Also, you may want to change the temperature setting lever positions. program dial that's one-half hour before this time and insert a red pin. The half-hour head start gives the furnace time to heat the house before you wake up or arrive home. WINTER SUMMER 1 NIGHT ENERGY SAVING PERIOD DAY ENERGY SAVING PERIOD 1 BEGINS 10:00 PM ENDS 6:00 AM BEGINS 7:30 AM ENDS 4:00 PM PROGRAM PROGRAM TEMPERATURE PIN IN TEMPERATURE PIN IN °C CONTROL °F °C CONTROL °F 14 58 27 BLUE 80 RED 68 58 68 20 14 20 RED BLUE RED 75 80 75 24 27 24 BLUE RED BLUE M8677 Setting the Heating Program Decide when you want the temperature to reach the comfort level. Find the notch on the 12 NOT APPLICABLE ON HEATING-ONLY MODEL. Fig. 5--Program examples. 69-0563--2 Decide when you want the energy savings period to start and insert a blue pin at the notch that corresponds to this time. After the blue pin engages, the furnace will be off until room temperature drops to the energy savings setpoint. You can set both a day and night program. for program examples. Setting the Cooling Program Decide when you want the temperature to reach the comfort level. Find the notch on the program dial that's one-half hour before this time and insert a blue pin. The half-hour head start gives the air conditioner time to cool the house before you wake up or arrive home. Decide when you want the energy savings period to start and insert a red pin at the notch that corresponds to this time. [. . . ] Set the thermostat cover on a table near thermometer of known accuracy. Allow at least five minutes for cover thermometer to sense area temperature, then compare the readings. Be careful not to touch thermometer or breathe on it. If the readings are the same, replace cover and put the system into operation. 21 If the readings are different, insert a small screwdriver in the thermometer slot, shown in Fig. [. . . ]