User manual HONEYWELL V5832A DATASHEET

[. . . ] SMALL LINEAR VALVES PN16 FOR MODULATING AND ON/OFF-CONTROL SPECIFICATION DATA V5832A/5833A, C FEATURES · · · · · · V5832A V5833A Small size allows installation where space is limited Long stroke results in a high quality characteristic Soft seat provides low leakage rate and high rangeability Reduced kVS values in the bypass to facilitate hydronic balancing Range of fittings available for different connections (soldered, threaded) Adjustment cap for manual operation Flat surfaces on body to fit installation tools Flat sealing connections in standard sizes Valve inserts changeable without draining by using insert replacement tool WV 108 40 mm distance between ports A/AB and the bypass (V5833C, only) · · · · SPECIFICATIONS V5833C Models Two-way V5832A Three-way V5833A Three-way with bypass V5833C Two-way stem up to open, port A to B; Three-way stem up to close, port A to AB PN16 see tables on page 2 and 3 0. 02% of kVS Brass DN15 (1/2"), DN20 (3/4") Stainless steel Brass Water, with max. [. . . ] If the p-values exceed 60 kPa, attention should be paid to the development of noise. Fig. Three-way valve operation Two-Way Valves Direction of flow always from port A to port B Port B: Outlet Three-Way Valves with Bypass These valves simplify the installation, which is depending on the layout of the pipework, as the bypass pipe is part of the valve. The information for the normal three-way valves is also valid for this type. + - inlet + outlet outlet inlet inlet + - inlet + - AB B A AB B A Fig. Three-way valve with bypass 3 EN0B-0308GE51 R1002 V5832A/V5833A, C SMALL LINEAR VALVES PN16 MOUNTING When installing the valve care must be taken that the flow direction is correct (see section "Typical Operation"). The valve must not be mounted with the stem pointing downward. The adjustment cap must be removed from the valve only when the actuator is fitted. The valve should be installed as stress-free as possible with a tightening torque of 25 to 30 Nm. The valve is supplied complete with mounting instructions. [. . . ] Printed in Germany EN0B-0308GE51 R1002 Manufacturing location certified to [. . . ]