User manual HONEYWELL Y6630D1007

[. . . ] 7 System check . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Radio transmission check. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Teach-in (single devices only) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Assignment to the relay module HC60NG. . . . . . . . . . . . . [. . . ] 6: Wiring the terminal Caution Incorrect wiring! Install in accordance with local wiring regulations. Observe ambient temperature and current limits (see HC60NG wiring label). g. 7: Wiring schemes 2 1 2 Fig. 8: Closing the terminal and housing cover 5 Installation 3. 2. Installation room unit HCW 80 Insufficient data transfer!Interference of the radio receiver in the device through metallic objects or further radio devices. WARNING Ensure there is sufficient distance to metallic objects. Mount the device with a distance of at least 1 m to radio devices such as radio headphones, cordless phones according to the DECT standard, etc. Select another installation site if the radio interference cannot be rectified. Fig. 11: Drilling scheme (measurements in mm) Drill the holes. Insert the supplied AA batteries with the correct battery polarity (see Fig. 9: Positioning the room unit HCW 80 Place the room unit HCW 80 at the installation site. Remove the housing cover of the room unit HCW 80 (see Fig. 12: Battery polarity and send button 2 The batteries have to be replaced when the red LED at the room unit HCW 80 flashes (see section "9 Changing batteries"). 1 Fig. 10: Removing the housing cover Place the housing cover in position above and snap it down (see Fig. 13). Mark the drill holes according to the drilling template (see Fig. 13: Placing housing cover in position 6 Checking 4. 4. 1. Checking System check 5. 2. Failed teach-in If the teach-in has failed: See section "5. 1 Assignment to the relay module HC60NG". Improve the data transfer. Adjust the set point of the room unit HCW 80 to 30 °C. If the room temperature is >30 °C the relay module HC60NG is switched on. Change the set point of the room unit HCW 80 to 5 °C. If the room temperature is <5 °C the relay module HC60NG is switched OFF. Improving the data transfer 4. 2. Radio transmission check When selecting the operating site of each device ensure that the distance to radio devices such as radio headphones, cordless phones, etc. according to the DECT standard amounts to at least 1 m. Do not install the devices over metallic wall connecting sockets and at least 30 cm away from the cover of the heat generator. Correct the installation site of the room unit HCW 80 if necessary. The room unit HCW 80 can send a test signal to the assigned relay module HC60NG in order to test the signal strength. [. . . ] Eliminate interference sources (metal, wireless devices). Follow the teach-in procedure as described in section "5". WEEE directive 2002/96/EC ­ Waste Electrical and Electronic Equipment directive 10. 3. Specifications HC60NG Electrical Receiver power supply Switch type Output rating Wire access (receiver only) 230 V AC (+10 %, ­15 %), 50 Hz SPDT potential free 24-230 V AC, 10 A resistive, 3 A inductive, 0. 6 p. f. [. . . ]