User manual HOOVER 39000067

[. . . ] Descrizione - Description - Beschreibung - Descripcion 1 2 3 4 15 17 21 21a 28 34 36 38 43 48 52 54 55 61d 63a 66 70 85 89 91 94 97 102 105 112 120 157 Motor mount - fan end Motor assembly Motor mount - commutator end Screw Chassis Rear wheel Front wheel Castor support Washer Bag door Screw Top cover Bag housing Extension tube Crevice tool Furniture nozzle Dusting brush Hepa filter Seal (Exhaust) Bag door seal Pre-motor filter Pressure switch tube On/Off button / switch button small Filter cover Spring Wheel cover Seal Motor support Cord reel harness Floor nozzle Handle tube upper (curved hose end) Copyright 2004 Gias S. Descrizione - Description - Beschreibung - Descripcion 163 165 176 184 185 186 213a 249 250 251 257 262 263 280 284a 285 299 305 306 307 308 309 310 312 314 358a 542a 802 898 900 901 Plug Valve Inlet housing Noise reducer Baffle plate Noise reducer Latch ring Cord reel pedal Control panel Motor housing Roundel (Hoover emblem) Adapt swivel connector (hose end) Flexible hose without edges Cord reel complete Swivel hose connector seal Button spring Turbo nozzle Infra red switch panel Infra red housing Infra red cover Switch activator printed Battery cover Handset module infra red Infra red remote control hose complete Motor harness Inlet duct Tool holders kit Seal Porous container(Eco-Box) Inlet housing switch Park switch actuator Copyright 2004 Gias S. DISCOVERY Suction Cleaners Discovery Fitting Notes Before carrying out any repairs on the appliance remove the following: Dust Container Press the dust container handle . [. . . ] Removing the screw allows the module to be lifted off. When removing the module take care to note the position of the connector plugs and amp tags fitted on it. When replacing the module make sure that the plastic shoulder washer is fitted under the head of the fitting screw. If the two wire plug from the cord reel is inadvertently fitted in between the two amp tags, the cleaner will run constantly when connected to the mains without the need to actuate the on –off switch:DO NOT under any circumstances connect the lead in this position. ON some models this position on the board may be used for the P T O Socket. motor and Cord Reel Removal Remove the top cover. Remove the four recessed screws around the dust container area. Detach the cord reel two pin connector from the module. The bag housing with the motor housing assembly and module attached to it can now be taken out of the appliance. To Remove The Motor:Detach the remaining connectors from the module and separate the motor housing from the bag housing. DISCOVERY Suction Cleaners Pull off the large square motor mount/cover from the front of the motor housing. Lift the plastic motor shroud containing the motor, out of the housing Motor and Cord Reel Continued:The motor, including the cylindrical foam baffle can now be removed from the shroud for servicing or replacement. Make sure that the foam baffle is re - fitted to the motor before replacing the motor. When replacing the motor into the shroud make sure that the rear motor mount is seated correctly in the base of the shroud without trapping the leads of the motor harness. [. . . ] Check condition of the mains lead ---------------if chipped or burnt, take appropriate action. Bond the Live and Neutral pins with one of the meter clips and connect the other meter clip to a terminal screwdriver. Insert the screwdriver through the grill onto the fan casing. [. . . ]