User manual HOOVER A2101

[. . . ] Stand on or wrap the power cord around arms or legs when using the cleaner. Remove the cyclonic cassette before removing the hose from the cleaner. Use the appliance to clean people or animals. Insert the hose end into the cleaner, ensuring it clips and locks into position. [. . . ] Fit the hose/handle and floor nozzle onto opposite ends of the telescopic tube (P2 & P3). The accessory tools can be stored on the tool holder fixed to the telescopic tube (P3). Power supply - Pull cord and plug into power supply (P4), Please make sure the cord is fully extended before using the cleaner (do not pull the cord beyond the red marker). press the on/off pedal once to start the cleaner (P5). Press it again to stop the cleaner before removing the plug after use. Press the cord rewind button to wind the power cord back into the cleaner (P6). Fixed power control (depending on model) - Adjust the suction by moving the handle valve: suction will decrease when opening the valve (P7). Variable power control (depending on model) - Slide the variable power adjuster to increase or decrease the power level (P8). Telescopic Tube / Telescopic Tritube (depending on model) ­ The Telescopic Tube or Tritube can be extended or collapsed by pressing the latches forward and pulling or pushing the tubes to the desired length (P9). Carpet & Floor Nozzle - Press pedal on the nozzle to lower the brush head when cleaning hard floors (P10). Press the pedal again to lift the brush head when cleaning carpets. Wash the foam filter using warm water (P25). Remove excess water from the filter and leave to dry fully before re-using. Gently tap and wash the micro filter attached to the filter frame using warm water (P26). Remove excess water from the filter and leave to dry fully before re-using. Remove excess water from the filter and leave to dry fully before re-using. Check if there is any other blockage in the system - Use a rod or pole to remove any blockage from the extension tube or flexible hose. Warning -The cassette check indicator will remain illuminated if the cleaner is used when the cassette is full, if there is a blockage or if the filters are dirty. If used for a period of over ten minutes with the cassette check indicator illuminated, an electronic cut out will switch the cleaner off to prevent any risk of overheating. If this should happen, switch the cleaner off, unplug and correct the fault (see ' Removing a blockage from the system'). The cut out will automatically reset upon switching the cleaner back on. Should you have a problem with the product, complete this simple user checklist before calling your local Hoover service . [. . . ] Should you have a problem with the product, complete this simple user checklist before calling your local Hoover service . Is there a working electricity supply to the cleaner?These are available from your local Hoover Dealer: Cyclonic cassette filter pack: U43 - code: 35600727 Purefilt exhaust filter: T87 - code: 35600541 HEPA exhaust filter: T93 - code: 35600632 Complete flexible hose assembly: D93 - code: 35600544 Carpet & Floor nozzle: G85 - code: 35600545 Parquet Caresse nozzle: G89 PC - code: 35600659 Miniturbo nozzle: J26 - code: 35600543 Allergy defender spray: A30S - code: 35600450 Allergy defender granules: A31G - code: 35600451 Should you require service at any time, please call your local Hoover Service office. By ensuring this product is disposed of correctly you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ]