User manual HOOVER AB135

[. . . ] Open the door and place the dirty dishes inside the appliance. Opening the door when a programme is running is not recommended especially during the main wash and final hot rinse phases. However, if the door is opened while a programme is running (for example, to add dishes) the machine stops automatically and the display will flash the remaining time before the end of the cycle. Close the door, without pressing any buttons. [. . . ] To pause, hold the running programme button down for at least 2 seconds and release when the corresponding indicator light starts flashing. Simply press the programme button again to restart the cycle from where it left off (the indicator light will stop flashing and remain on). After pressing the "ON/OFF" button, the indicator light which is factory set at "recommended", or the indicator light for the "Auto Memory" programme will flash. To select an option, press the corresponding button (the indicator light will light up). Option buttons must be pressed BEFORE starting the programme for them to be accepted. To choose another programme, press the corresponding button (the relevant indicator light will flash to confirm the selection). to start the programme , press the selected programme button again to confirm. The programme starts automatically, the relevant indicator light will stop flashing and remain on and the cycle length will appear on the display. If the previously described operations were performed with the door open, the programme will not start until the door is closed. When a programme is running, the time until the end of the cycle will be displayed and the 4 "PROGRAM STATUS" indicator lights: = "WASH" = "RINSE" = "DRY" The "POWER JET" option always guarantees the best results by more effectively dealing with heavier soiling. By using this option, the strength of the selected cycle will be increased, adding one rinse and increasing the temperature and water pressure in the washing phase where foreseen. Wait for the alarm to sound to indicate that the settings were saved. To turn the alarm on again, follow the same procedure ("b1" will appear on the display to indicate that the alarm is on). IMPORTANT This dishwasher is equipped with an anti-overflow safety device which will automatically discharge any excess water should a problem occur. To ensure the correct operation of the anti-overflow safety device, we recommend that the dishwasher is not moved or tilted during operation. If however it is necessary to tilt or move the dishwasher, please ensure that the washing cycle is complete and that there is no remaining water inside the dishwasher. Wash with prewash If setting the INTENSIVE wash programme, a second dose of about 20 g of detergent (1 table-spoon) must be added directly in the machine. ("RECOMMENDED" PROGRAMME) Once a day - for normal soiled pans and any other items that have been left all day for washing. Once a day - for heavily soiled pans and any other items that have been left all day for washing. Suitable for heavily soiled items that are to be washed straight after a meal (Max 8 place load). - WASHING CLASS AEnergy Saving Programme suitable for normal soiled items. Quick wash for dishes which are to be washed immediately after the meal. [. . . ] Short cold pre-wash for items that are stored in the dishwasher until you are ready to wash a full load. Depending on the source of the supply, water contains varying amounts of limestone and minerals which are deposited on the dishes leaving whitish stains and marks. The higher the level of these minerals present in the water, the harder the water is. The dishwasher is fitted with a water softener unit which, through the use of special regenerating salt, supplies softened water for washing the dishes. [. . . ]