User manual HOOVER AC110

[. . . ] Please note that during use, the light goes on from time to time but you "Rinse indicator" ligh You should rinse the boiler in order to avoid deposit of scale. You will need to wait a little bit steam is ready before restarting ironing. Please refer to the steam ready led paragraph for more detail. In order to facilitate the carrying and the storage of your ironing system, your appliance is designed with a lock system (2). [. . . ] Press the iron on/ turned up and inform you that the appliance is running on. Select the temperature of the soleplate by turning the dial (12) on the iron to the will indicate you that the soleplate has reached the requested temperature. Help: To know the best suitable temperature for each textile, check the laundry care label of the article to be ironed. Please note that during use, the temperature light goes on from If you select a lower temperature while ironing, wait until the iron has cooled down to the set temperature before you continue ironing. If the temperature is too low, some drops of water could escape from the soleplate. Please raise up the temperature abov to avoid this issue Dry Ironing Domestic Iron Models: Select the temperature of the soleplate following the indications of chapter 3. Start your ironing without pressing the steam trigger (13), when the soleplate reaches the appropriate temperature. Start your ironing when the soleplate reaches the appropriate temperature. On the stand, when the steam will be ready to be used, the dedicated lamp (1d) will Steam lock function: The steam lock allows you to steam iron without pressing the steam trigger. steam will therefore escape continuously. To activate or deactivate the steam lock, slide forwards or backwards the steam lock (13). Models with "Rinse" Light Only remember to clean the boiler before use next time you plan to iron. Proceed as followed: Before going on, be sure that the appliance is cooled down and unplugged for at least 2 hours. Unscrew the boiler rinse safety cap anti-clockwise with a coin and remove it. Fill the boiler with 0, 2 litres of tap water using a bottle and a in the sink. we recommend repeating this operation twice. Screw the boiler rinse safety cap with a coin and put back the calc removal cap (17). Next time you will plug and switch on your appliance, the rinse light (1e) will start your ironing session immediately. Models Without "Rinse" Light Before proceeding, be sure that the appliance is cooled down and unplugged for at least 2 hours. Unscrew the boiler rinse safety cap anti-clockwise with a coin and remove it. Fill the boiler with 0, 2 litres of tap water using a bottle and a in the sink. we recommend repeating this operation twice. [. . . ] "Istituto del Marchio di Qualità" (IMQ) ), the independent italian national authority for the safety of domestic electrical appliances, ensures that European safety standards are met and maintained throughout the production life of an appliance. All appliances that pass the requirements are permitted to carry the IMQ mark of safety. quality ISO 9001 Hoover's factories have been independently assessed for quality. Our products are made using a quality system which meets the requirements of ISO 9001 The Environment This appliance is marked according to the European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). [. . . ]