User manual HOOVER AC164

[. . . ] If you require to use an extension cable, only use earthed extension leads with safety approval marking (i. Always fully unwind the extension lead before use and connect via a RCD protection device. Heavier than necessary, only the amount of liquid strictly necessary to clean the surface should be placed in the top liquid tank. TOP TANK REMOVAL: Simply turn the cap-knob anti-clockwise until the retainer is released (fig. [. . . ] It is important to comply with the dosage recommended to avoid the production of foam, which may damage the suction circuit. The machine is designed to wash and dry hard surfaces, in an environment-friendly way, since the mechanical action of the revolving brush allows cleaning with the aid of water only. As the machine moves forward, the dirt removed by the brush and the liquid delivered to dissolve it are picked up by the suction of the machine, which allows virtually, instantaneous drying. Operation with a water and detergent solution is possible for stubborn dirt, disinfection or giving fragrance to surfaces. The machine must only be used for this purpose. It provides its best performance if used correctly and kept in good working order. You are therefore requested to read this instruction manual carefully and to reread it whenever difficulties arise in use of the machine. Clean solution tank cap - release handle 8. UNPACKING THE MACHINE The machine is sold with all parts already assembled except for back hoses. After removing the machine from the packaging make sure that it is intact. If in doubt do not use it and contact your dealer or an Authorised Service Centre. - Prepare the surface for cleaning by using a brush or vacuum cleaner to remove crumbs , hairs , soil , lumps of dust , etc. The machine will give its best performance on surfaces which have first been brushed, so they are ready for washing and drying. 1) to deliver the detergent liquid, at a flow rate to suit the floor surface and the type of dirt. Take care not to wet the floor more than necessary. - Move the machine slowly forward and back, following a washing pattern as shown in figure 9 if possible. - Keep using the rotating brush in the most difficult points to remove the most stubborn dirt. WARNINGS - Before starting to wash the floor, users are advised to try out the machine on a small area to check whether the detergent about to be used is suitable for the surface to be cleaned and to perfect the method of use. - Do not leave the machine stationary with the rotating brush on. - The detergent solution dosage must ensure that the squeegee blades do not work dry. THE MACHINE DOES NOT DRY - Check that the suction squeegee blades are properly positioned and that their end retainers are closed (see maintenance section) (fig. If necessary replace them, referring to the maintenance section. [. . . ] - Free the brush by taking hold of it from the side of the 2 screws just removed and extract if from the pin on the opposite side. - Clean the brush under running water, taking care to dry it perfectly before putting it back in place. - Re-close by tightening the 2 screws, taking care not to trap the bristles of the brush. CLEANING THE SQUEEGEE BLADES - To remove the squeegee blades, they must be separated by releasing the retainers at the ends (fig. [. . . ]