User manual HOOVER AC176

[. . . ] It is ideal for gentle dusting on all surfaces. REMEMBER - Make sure handle is fully clicked into place after use. 10 Maintaining performance 11 EMPTYING THE DUST CONTAINER For peak performance we recommend the dust container is emptied on a regular basis. Filling must not exceed the maximum level indicated on the dust level viewing window. REMEMBER ­ Always switch off and unplug the machine from the electricity supply before maintaining your cleaner. [. . . ] The HEPA and foam pre-motor filters and vortex tube are located beneath the dust container lid (14a). The exhaust filter is located below the dust container (16b). REMEMBER ­ Always switch off and unplug the machine from the electricity supply before maintaining your cleaner. 14a 14b 14c 14 Cleaning the pre-motor filters For optimum performance clean the HEPA pre-motor and foam pre-motor filter after each dust container empty. (14a) Rotate the pre-motor filters cover anticlockwise. (14b) The HEPA and foam pre-motor filters and the vortex tube are attached to the lid. (14e) Tap the HEPA pre-motor filter against an hard surface and shake the foam filter to remove dust. 15 Washing the pre-motor filters For optimum performance wash the pre-motor filters after 5 dust container empties. (15a) Wash the HEPA and foam pre-motor filters under hand warm water. If preferred, remove the HEPA filter from the lid prior washing (15b). Allow to air dry thoroughly before refitting. Reassemble the components by reversing the above process. A thermal cut out switches off the cleaner automatically to prevent overheating if the cleaner is used when the dust container is over full, or the filters require cleaning, or there is a blockage. If this should happen switch off and unplug the machine from the electricity supply. To correct the fault please refer to sections 12-18. ii) NOTE: It will take about 30 minutes for the thermal cut out to automatically reset. If your cleaner is not working properly, run through the following checklist: REMEMBER ­ Always switch off and unplug the machine from the electricity supply before maintaining your cleaner. i) ii) iii) iv) v) Is the dust container overfilled?(refer to sections 12 and 13) Is the hose blocked?(refer to section 17) Is there a blockage in the cleaner base?(refer to section 18) Are the filters blocked?(refer to sections 14, 15 and 16) Are the brushes rotating?(refer to section 19) REMEMBER - If there is any doubt, call the Hoover Advice Helpline (open 7 days a week) on 08705 400600. They may be able to assist you over the telephone. www. hoover. co. uk 11 Important information Genuine Hoover Spares Always replace parts with Genuine Hoover Spares. [. . . ] When ordering parts, always quote your model number. Hoover Service Should you require service at any time, please call your local Hoover Service Office. Hoover have a computerised nationwide service network of over 500 engineers who will respond quickly to your call and guarantee your repair for 12 months. Safety and the Environment As the owner of a new Hoover product, we would like to tell you more about the high standards we have set in safety and the environment. [. . . ]