User manual HOOVER AC270

[. . . ] SAFETY WARNING: The polisher must be switched off and the plug disconnected from the electrical supply before fitting or changing the brushes. Place each brush or pad on its axle and press until a click indicates that it is the correct position. To remove brushes or pads, grasp them and pull towards you. Ensure the handle is in the upright position before inserting the plug into the electricity supply. [. . . ] During the wax-spreading phase with the Yellow or Black brushes, press the foot switch to reduce brush rotation speed, reduce noise level and save energy. When the rotation speed is low one Orange light is illuminated When the wax-spreading operation is finished, press the foot switch (Fig. 7) to return to high speed and start the polishing phase. When the rotation speed is high two Orange lights are illuminated SAFETY WARNING: The polisher must be switched off and the plug disconnected from the electrical supply before fitting or changing the brushes. ACCESSORIES Hoover polishers are equipped with spring loaded brushes and pads Hoover polishers are equipped with spring loaded brushes and pads in in order to obtain the best results on on floors with uneven surface. Order to obtain the best results even floors with uneven surface. For this reason, the small narrow brush positioned the front of of For this reason, the small narrow brush positioned on on the frontthe the hood is also spring loaded. Three kits of brushes and pads are supplied with the polisher: Three kits of brushes and pads are supplied with the polisher: Yellow Hard Bristle Brushes (Depending on model) Yellow Hard Bristle Brushes (Depending on model) To be used to remove the old polish then to spread the new wax evenly on To be used to remove the old polish then to spread the new wax evenly on the floor. Black Soft Bristle Brushes Black Soft Bristle Brushes Must be used to complete the first polishing phase. Suitable for all hard Must be used to complete the first polishing phase. They can be used on all hard surfaces, but are especially suitable for marble They can be used on all hard surfaces, but are especially suitable for marble and tiles. wind supply cord around the 2 clips on the handle tube. To maintain brushes in good condition, always remove them before storing the polisher. 1) Is there a working electricity supply to the polisher?Please remember: A service charge will be made if the polisher is examined and found to be in working order, has not been assembled in accordance with these instructions, or has been misused. Call your nearest Hoover Service Centre in the event of dissatisfaction Ensure that all service and repairs are carried out by an authorised Hoover Service Engineer. Replace the paper dust bag as soon as the bag check indicator activates. Always switch off and remove the power plug from the electricity supply after use and before cleaning the appliance or attempting user maintenance as described in these instructions. Use your polisher out of doors, on wet surfaces or for wet pick up. Pick up matches, hot ashes, cigarette ends or anything that may damage the product. Spray with or pick up flammable liquids, cleaning fluids, aerosols or their vapours as this may cause risk of fire/explosion. Run over, stand on, or wrap the power cord around arms or legs when using your cleaner Remove the plug by pulling on the power cord. [. . . ] Please contact the nearest Hoover Spare Parts Point for any information and for the supply of spare parts. Ensure that all the repairs are carried out by Hoover authorised personnel only. Before cleaning and maintenance by the owner, remember to switch off the appliance and pull out the plug. 09178369) Use only original Hoover spare parts. [. . . ]