User manual HOOVER AC73_AC20 A-CUBED

[. . . ] Do not stand on or wrap the cord around arms or legs when using your appliance. Do not use the appliance to clean animals or people. Do not position the appliance above you when cleaning the stairs. The Environment The symbol on this appliance indicates that this appliance may not be treated as household waste. [. . . ] To avoid a safety hazard, an authorised HOOVER service engineer must replace the power cord. Parking and Storage - The tube can be parked for temporary storage while in use, or in the storage position when not in use. [10] Accessories To obtain the best performance and energy efficiency it is recommended that the correct nozzles are used for the main cleaning operations. These nozzles are indicated in the diagrams by the letters GP, HF or CA. A nozzle type GP can be used to clean both carpet and hard floor. A nozzle type HF is suitable for use only on hard floor. A nozzle type CA is suitable for use only on carpet. The other nozzles are accessories for specialist cleaning tasks and are recommended for occasional use only. It is important to note that this vacuum cleaner is supplied with an Energy Label as required by European Regulation (EU) 665/2013. If the label shows a red prohibition circle on the left covering the carpet symbol, then this indicates that the vacuum cleaner is not suitable use on carpets. If the label shows a red prohibition circle on the right covering the hard floor symbol, then this indicates that the vacuum cleaner is not suitable for use on hard floors. [20 , 21] Remember: Do not use hot water or detergents. In the unlikely event of the filters becoming damaged, fit a Genuine Hoover replacement. Do not try and use the product without a dust bag or filter fitted. Cleaning the permanent cloth dust bag* To maintain optimum performance we recommended that you wash the permanent cloth dust bag under warm water after every 5 full bags. Remove excess water and leave to dry fully before replacing. Removing a blockage from the system (*Certain model only) If the bag check indicator LED is illuminated or flashing: 1. Check if there is any other blockage in the system - Use a cord or a pole to remove any blockage from the telescopic tube or flexible hose. Warning - The bag check indicator LED will turn on if the cleaner is used when full, if there is a blockage or if the filters are dirty. If the cleaner is used for a significant period of time with the bag check indicator LED is on, a thermal cut out will switch the cleaner off to prevent overheating. The bag check indicator LED turns off once the cleaner has switched off to signal that the thermal cut out has been activated. If this should happen, switch the cleaner off, unplug and correct the fault. [. . . ] In this case refer to ‘remove A Blockage From the System’. Cleaning the Filters* To maintain optimum performance of your cleaner, please wash the filters after each 5 bag changes. USER CHECK LIST Should you have a problem with the product, complete this simple user checklist before calling your local Hoover service. €  Is there a working electricity supply to the cleaner? [. . . ]