User manual HOOVER AE136

[. . . ] Keep all documentation in a safe place for future reference or for any future owners. Check that no damage has occurred to the machine during transit. If it has, call for service by GIAS. Call 08705 400 600 Delivery information Please check that the following items are delivered with the appliance: Instruction manual Guarantee card Vent kit and instructions Energy label Unpacking the product Remove the machine from its packaging close to the final location of the machine. Cut carefully around the base of the packaging and up one corner. Remove the polythene sleeve and lift the dryer off the polystyrene base. If the appliance is not running properly or breaks down, switch it off, disconnect the plug from the socket and do not tamper with the appliance. [. . . ] Check that the supply circuit is rated to at least 13A. This appliance is fitted with a moulded-on non-rewireable plug which is already equipped with a BS 1362 ASTA approved 13A fuse. Any replacement must be the same rating and specification. If the fuse cover is lost, do not use the plug until it is replaced. The socket outlet and the plug on the appliance must be of the same type. Do not use multiple adapters and/or extension leads. You may be charged for a service call if a problem with your machine is caused by incorrect installation. The plug should be accessible for disconnection after the appliance has been installed. The wires in the mains lead are coloured in accordance with the following codes: Blue Brown Green and Yellow NEUTRAL LIVE EARTH CE Appliance complies with European Directive 89/336/EEC, 73/23/EEC and subsequent amendments. Adjusting the feet Once the machine is in place the feet should be adjusted to ensure that the machine is level. Adjust the four feet to ensure the machine is firm and level. If the mains cord on this appliance is damaged, it must be replaced by a special cord which is ONLY obtainable from the Hoover spares service. It must be installed by a competent person. Call 01204 556111 6 40005096. qxd 24/05/2007 12:10 Page 7 Ventilation Adequate ventilation must be provided in the room where the tumble dryer is located to prevent gases from appliances burning other fuels, including open fires, being drawn into the room during operation of the tumble dryer. Exhaust air must not be discharged into a flue which is used for exhausting fumes from appliances burning gas or other fuels. Check regularly that the air flowing through the dryer is not restricted. To restart the dryer, close the door and press the `ON/OFF' button. WARNING!When the tumble dryer is in use the drum and door may be VERY HOT. Never stop a tumble dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. Filter IMPORTANT: To maintain the efficiency of the dryer check that the fluff filter is clean before each drying cycle. Gently remove lint using a soft brush or your fingertips. Snap the filter together and push back into place. Filter Care Indicator Lights when the filter needs cleaning. If the laundry is not drying check that the filter is not clogged. The indicator will also light when the venting hose is blocked or kinked. 12 40005096. qxd 24/05/2007 12:10 Page 13 Operation Refer to the Drying guide table or the fabric labels to select the most suitable programme. Open the door and load the drum with laundry. Ensure that garments do not hinder closure of the door. If drying delicate items press the `ACRYLIC/SYNTHETIC' button to reduce the heat level. Press again on completion, to select high temperature. [. . . ] Check using another appliance such as a table lamp. Is the plug properly connected to the mains supply?Is the dryer switched on, both at the mains supply and at the machine?Has the drying time or the programme been selected? [. . . ]