User manual HOOVER AM 115

[. . . ] This appliance complies with Directives 89/336/EEC, 73/23/EEC and following changes. Q Do not touch the appliance with wet or damp hands or feet. Q Do not use the appliance when bare-footed. Q Extreme care should be taken if extension leads are used in bathrooms or shower rooms. [. . . ] Press the plug (to be found in the envelope with the instructions) into the hole. Fix the sheet of corrugated material on the bottom as shown in picture. The appliance must be connected to the water mains using new hose-sets. Hook the outlet tube to the edge of the bath tub, paying attention that there are no bends or contractions along the tube. It is better to connect the discharge hose to a fixed outlet of a diameter greater than that of the outlet tube and at a height of min. If is necessary to use the plastic sleeve supplied. EN Use front feet to level the machine with the floor. A) Turn the nut clockwise to release the screw adjuster of the foot. B) Rotate foot to raise or lower it until it stands firmly on the ground. C) Lock the foot in position by turning the nut anticlockwise until it comes up against the bottom of the machine. After installation, the appliance must be positioned so that the plug is accessible. We found only one brand always lives up to our exacting standards and provides outstanding cleaning across a broad range of dirt and stains, as well as providing high levels of fabric care. That's why Hoover gave Ariel their official seal of approval. A guide environmentally friendly and economic use of your appliance. MAXIMISE THE LOAD SIZE To prevent any possible waste of energy, water or detergent we recommend that you put a full load in your washing machine, not exceed the maximum loads shown below: Cotton and linen 5 kg Mixed 2 kg Very delicate 1, 5 kg Wool 1 kg Save up to 50% energy by washing a full load instead of 2 half loads. SAVE detergent, time, water and between 5 to 15% energy consumption by NOT selecting Prewash for slight to normally soiled laundry. Pretreat stains with stain remover or soak dried in stains in water before washing to reduce the necessity of a hot wash programme. Save up to 50% energy by using a 60°C wash programme. The maximum load for heavy fabrics is 5 kg, while, in the case of delicate fabrics, it is advisable not to exceed 2 kg (1 kg in the case of machine washable articles in "Machine Washable Woolens") so as to avoid the formation of creases which may be difficult to iron. A net bag should be used for particularly delicate fabrics. Let us suppose that the washing consists of HEAVILY SOILED COTTON (tough stains should be removed with suitable stain removal). It is advisable not to wash a load made up entirely of articles in towelling fabric which absorb a lot of water and become too heavy. [. . . ] Detach the drainage hose from the clamp and lower it over the bowl until all the water is removed. Repeat the same operation with the water inlet hose. Does not function on any programme CAUSE Mains plug not plugged in Mains switch not on No power Electric circuit fuses failure Load door open Insert plug Turn on mains switch Check Check Close load door Check Turn on water inlet tap Set timer on correct position Straighten discharge tube Check filter Replace washer and tighten the tube on the tap Wait a few minutes until the machine discharges water Turn the programme dial onto spin setting Adjust special feet Remove transport bracket Distribute the washing evenly See cause 1 Inlet tap turned off Timer not set correctly Discharge tube bent Odd material blocking filter Leak from the washer between the tap and inlet tube The washing machine has not discharged water "No spin" setting (some models only) Strong vibrations during spin Washing machine not perfectly level Transport bracket not removed Washing load not evenly distributed For prompt servicing, give the model of the washing machine, to be found on the label placed on the cabinet inside of the porthole or on the guarantee certificate. Important 1 The use of environment friendly detersives without phosphates may produce the following effects: - The discharge rinse water may result cloudier due to the presence of zeolites in suspension. [. . . ]