User manual HOOVER AWMPD 410LH8/1-S

[. . . ] We are proud to always offer new, innovative and technologically advanced products, with a complete range of home appliances to ensure true assistance in your daily routine. Carefully read this manual for correct and safe appliance use and for helpful tips on efficient maintenance. Only use the washing machine after carefully reading these instructions. We recommend you always keep this manual on hand and in good condition for any future owners. [. . . ] L By this option you can change thetemperature of the washing cycles. To prevent damage to the fabrics, it is not possible to increase the temperature above the maximum value set for each programme. After starting the washing machine you need to wait a few seconds before the appliance starts the programme. cYCLE DURATION l When a programme is selected the Display automatically shows the cycle duration, which can vary, depending on the options selected. L By this option you can reduce the maximum spin speed for the set programme, until it is completely excluded. L If the label does not show any instructions, you can spin to the maximum speed set for the programme. To prevent damage to the fabrics, it is not possible to increase the speed over the maximum one set for each programme. L It is possible to modify the spin speed at any time, without shifting the machine to PAUSE. an over dosing of detergent can cause excessive foaming. If the appliance detects the presence of excessive foam, it may exclude the spinning phase or extend the duration of the programme and increase water consumption. The machine is fitted with a special electronic device, which prevents the spin cycle should the load be unbalanced. This reduces the vibration, improves noise reduction and prolongs the life of the washing machine. dELAY START button L This button allows you to pre-programme the wash cycle to delay the start of the cycle for up to 24 hours. L It is possible to cancel the delay start by pressing the ON/OFF button (for at least 3 seconds). sTEAM button L This button allows a specific treatment to follow certain wash cycles (please refer to the program table). L The steam function works by relaxing creases in wet garments and as a result reduces the time needed to iron these items. l The fibres are regenerated and refreshed by removing bad smells. L Every program provides a dedicated steam treatment in order to ensure the max imum cleaning efficiency according to the items fabric type and colour. This option must be selected before pressing the START/PAUSE button. L To delay the start use the following This button allows you to choose - Press the button once to activate it (0:00h appears on the display) and then press it again to set a 30 minutes delay (0:30h appears on the display). The pre-set delay increases by 30 minutes each time the button is pressed, until h24 appears on the display, at which point pressing the button again will reset the delay start to zero. - Confirm by pressing the START/PAUSE button (the light on the display starts to flash). [. . . ] Make sure transport screws, rubber bungs and spacer tubes were removed. Make sure there are no foreign objects inside the drum (coins, hinges, buttons, etc. The standard manufacturer warranty covers faults caused by electrical or mechanical faults in the product due to an act or omission of the manufacturer. If a fault is found to be caused by factors outside the product supplied, miss-use or as a result of the instructions on use not being followed, a charge may be applied. [. . . ]