User manual HOOVER C1404

[. . . ] Model Number_______________________ Serial Number_______________________ (Located on bottom of cleaner as shown) When using an electrical appliance, always follow basic precautions, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE Read these instructions before operating cleaner This cleaner meets Occupational Safety and health Act (OSHA-29 CFR 1910 Subpart S) requirements. This appliance is provided with double insulation. Close supervision is necessary when any appliance is used by or near children. Do not allow vacuum cleaner to be used as a toy or to run unattended at any time. [. . . ] Align opening in filter bag with dirt tube (B) inside the outer bag. How to use Handle release lever: step on lever to lower handle to operating or low position. Nozzle control knob: slide knob to correct setting for height of carpet being cleaned 9. Operate cleaner only at voltage specified on data plate on bottom of cleaner. WARNING: Electrical shock could occur if used outdoors or on wet surfaces. To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. if the plug does not fit fully in the outlet , reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Turn cleaner on and, with handle in upright position, pull back on handle until front of cleaner is lifted off the carpet. The handle of your cleaner has three positions; upright for storage and when using cleaning tools; operating for general operation on carpet and floors; low for reaching under low furniture. Step on handle release lever to lower handle. To move your cleaner from room to room, put handle in upright position, tilt cleaner back on rear wheels, and push forward. 21 The cleaner can also be moved Edge cleaning is provided on both sides of nozzle to remove dirt in carpet near baseboards and furniture. 24 If it is necessary to raise and The nozzle will not move into the adjusted position until the cleaner handle is lowered to the operating position. Disconnect cleaner from electrical outlet before attempting to service it in any manner. Do not operate without filter bag in place. Formance, the following carpet height settings are recommended. Setting 2 (B): if easier pushing effort is desired while maintaining good cleaning performance. cleaners with Four Settings: · Lowest setting (1): for bare floors and low pile, level loop, kitchen type carpet. ⷠNext setting (2): for other types of carpet. ⷠHigher settings (3-4): for very deep pile carpet where easier pushing effort is desired, while maintaining good cleaning performance. [. . . ] The belt must rotate freely inside the belt guide. If the agitator does not turn, remove bottom plate and reposition belt in the belt guide. 35 Place hood on cleaner body and press to snap all four latches. Pull up on hood slightly to make sure all four latches are secured. [. . . ]