User manual HOOVER C1633

[. . . ] Only) OR Call 1-800-263-6376 to speak with a representative in our Consumer Response Center; MonFri 8am-7pm EST. Donotusetopickupflammableorcombustibleliquidssuchasgasoline, orfinewood sandings, or use in areas where they may be present. Donotusewithanyopeningblocked;keepfreeof dust, lint, hair, or anything that may reduce air flow. Ifanextensioncordisabsolutely necessary, use at least a 16 gauge cord and as short as possible. [. . . ] If more dirt is allowed to accumulate, your cleaner may not operate effectively and spillage may occur when cup is removed. The dirt picked up by the cleaner is deposited into the dirt cup. When empty, the cup can be cleaned with a damp cloth or rinsed with water. To reduce twisting of the power cord, start at the cleaner handle end of the cord and coil before storing on storage hook. Disconnect cleaner from electrical outlet before attempting to service it in any manner. A passageway on the cleaner bottom plate improves the cleaning of carpet near baseboards and solid furniture. Slowly guide either side of cleaner along edge of carpet. Note: If the cleaner is difficult to push, move adjustment lever to next higher setting. This will decrease the belt load and pushing effort. It is necessary to raise and lower the nozzle for various carpet pile heights. For glue-down, short pile For carpet with normal and indoor-outdoor type pile height and for carpet. Removing loose dirt from hard surface floors. While holding bag closure clip, shake bag vigorously to release dirt accumulated in bag. 5 For carpet with normal For carpet with very pile height but thicker high pile height and density. While supporting bottom of cup, release the two latches by pulling them outward as shown. Reposition cup up into support at bottom of bag and snap latches into position. To prevent leaking, make sure dirt cup is positioned fully into seal at top of cup and is flat against the dirt tube as shown. If the belt is stretched, cut, broken, or if the agitator brushes are being replaced, replace the belt. To check belt, remove the bottom plate (see following section). Lift out agitator, remove old belt and place new belt in groove of agitator. Replace agitator by aligning the projection, located on one end of the agitator, with the slot in the wall of the cleaner base. Then push the agitator down into position. [. . . ] The motor is equipped with bearings that contain sufficient lubrication for the life of the motor. the addition of lubricant could cause damage. Therefore, do not add lubricant to motor bearings. Do not send your cleaner to Hoover in Glenwillow, Ohio for service, this will only result in delay. [. . . ]