User manual HOOVER CYCLONE BAGLESS

[. . . ] To disconnect hose from cleaner, press release buttons (C) on sides of Hose Connector and pull out. NOTE: The flexible hose contains electrical wires for connection to the Power Nozzle and should not be used if damaged, cut or punctured. To remove Wand from Hose, press on Wand Releases Button (F) on end of Wand and pull apart. To Release, step on Wand Release Pedal (H) and pull to disconnect from nozzle. [. . . ] The Hard Floor Brush is recommended for vacuuming wood, laminate coverings and ceramic floor surfaces. Power Nozzle may also be used for hard floor cleaning, by simply seting the Floor Selector to Bare Floor. Crevice Tool may be used in tight spaces, corners, and along edges in such places as dresser drawers, upholstered furniture, stairs and baseboards. Dusting Brush with swivel neck may be used to dust furniture, lamps, lighting fixtures, blinds, baseboards, shutters and registers. May also be used for upholstered furniture, draperies, tapestries and mattresses. Hard Floor Brush may be used for hard surface floors such as tile and slate. Turbine Hand Tool may be used for upholstered furniture and carpeted stairs. Power Nozzle may be used for carpets, rugs and hard floor surfaces. Firmly push tool into the hand grip or wand. Empty the Dirt Cup at the end of each cleaning session and before the dirt reaches the fill line. P Always unplug the vacuum cleaner from the electrical outlet before performing any general maintenance. 17 Remove Tool from Hose and turn it so bottom faces up. (See the following section for instructions) Insert Brushroll through Belt and position Belt over Gear Teeth (D) on Brushroll. With curved ends down, slide End Plates (C) of Brushroll into slots (E) on Tool. It is important that you use only genuine HOOVER ® parts to assure your cleaner operates at peak performance. 20 Replace Belt Guard (B) making sure not to pinch Turn Brushroll, making sure it rotates freely. 21 To replace Bottom Plate, insert the four tabs (F) on edge of Bottom Plate into slots on front of Tool. However, if the Belt is cracked, gouged or broken, it should be replaced. 22 Remove Tool from Hose and turn it so bottom faces up. Down, slide Retainers into grooves (H) on both sides of Tool Housing and snap into place. It is important that you use only genuine HOOVER® parts to assure your cleaner operates at peak performance. Before plugging in and switching the cleaner back "ON". [. . . ] Whenusedandmaintainedinnormalhouseholduse, andinaccordancewiththeOwner'sManual, yourHooverPlatinumCollectionTMBagless Cyclonic Canister is warranted against original defects in material and workmanship for a full six years from date of purchase (the "Warranty Period"). During the Warranty Period, Hoover ® will provide, as described in this warranty, labor and parts, at no cost to you, to correct any such defect in products purchased in the United States, U. If this product is not as warranted, take the product to a Hoover ® Authorized Warranty Service Dealer along with proof of purchase. This warranty does not cover: Brushroll, primary Filter, HEPA Filter, use of the product in a commercial operation (such as maid, janitorial and equipment rental services), improper maintenance of the product, damage due to misuse, acts of God, nature, vandalism or other acts beyond the control of Hoover ®, owner's acts or omissions, use outside the country in which the product was initially purchased and resale of the product by the original owner. [. . . ]